1.
Evaluation of Energy Loss(Permanent Pressure Loss) in Standardized Orifice Plate and Vortex Flow Meter
标准孔板与涡街的能耗(永久压力损失)估算
2.
An Analysis about Metering Additional Errors of Standard Orifice Plate Flow-meter in Measuring Natural Gas Flow-rate
标准孔板流量计测量天然气流量计量附加误差分析
3.
On the Theoretical and Practical Standards in the Doctrine ofConfucius s Benevolence;
试论孔子仁学的理论标准与实践标准
4.
Replace length cut springs to std. springs. Close blind holes.
将定尺弹簧改成标准弹簧.关闭盲孔.
5.
Practise in Art,Succeed in Music --The Standards of Artistic Aesthetics of Confucius
游于艺,成于乐——孔子艺术审美标准论略
6.
The Study of Examination Effect of the Drilling Technology to Standard Penetration Test;
钻孔工艺对标准贯入试验影响的研究
7.
"When tappings are needed at any other than the standard boss locations, a sketch must be provided clearly showing the exact location on the valve."
如果需要在上述标准以外的位置钻孔,请提供准确、清楚的设计图,标明阀体上准确的钻孔的位置。
8.
Make four indentations into the condenser near the standard cone joint.
在冷凝器接近标准圆锥接头处打四个穴孔。
9.
Definition of Phellinus Rimosus Polysaccharide Quality and Quantity Standard;
缝裂层孔菌发酵菌丝体多糖质量标准的确定
10.
Read Confucian Analects and Dissertate the Talents--Enlightenments from Confucius Value of the Standard of Talents;
读“子曰”,论人才——孔子人才标准的现代启示
11.
Standardization and Assessment of College Students Facial Expression of Emotion;
大学生面孔表情材料的标准化及其评定
12.
Cold Processing Technology of High-Specification Pure Titanium (Gr.2) Cross-Rolled Boring Tube
高标准纯钛(Gr.2)斜轧穿孔管的冷加工技术
13.
Comparative research on mechanical behaviors of slotted standard steel studs in web plate
腹板开孔标准轻钢龙骨力学性能比较研究
14.
Research and development of specific surface area standard reference materials of nonporous mono-disperse SiO_2 spheres
单分散SiO_2无孔微球比表面积标准物质的研制
15.
Study on classification standard of low-porosity and low-permeability reservoir at Heilongmiao area,Nanyang depression
南阳黑龙庙地区低孔低渗储层分类标准研究
16.
To allow for easy access and serviceability, the inspection port doors are hinged as a standard on belt guards.
容易靠近和维护，检查孔的门用标准绞链连接在皮带安全罩上。
17.
The max. depth of drilling is about 50 times of drill tools dia and have to see material for drill specially size.
本机种钻孔深度以钻头直径50倍为标准,特殊规格需视加工材质定.
18.
Studies on Determination Method and Quality Criteria of Residua of Macroporous Resins;
大孔吸附树脂有机残留物检测方法及其标准研究