1.
Fixed cistern barometers are used as a standard for checking altimeter.
固定槽式气压计可以作为标准件去检验测高计。
2.
Fixed cistern barometers are used as a standard for checking.
固定槽式气压计可以作为标准件去检验。
3.
Strong rectangular frame fixed by screws, an inset hole every25 cm to fix the slotting auger, guard board, bunches of cables and circuit diagram sidekicks, etc.
坚固的用螺丝固定的长方框，每隔25毫米有一个嵌孔，用来固定槽沟、板、缆束及线路图插袋等。
4.
Fixed cistern barometers are used as a standard for checking aneroid barometers.
固定槽式气压计可以作为标准件去检验无液气压计。
5.
The surface of the table is cut with T slots so that workholding devices such as the vise can be clamped to them.
工作台的表面切有T形槽以便工件夹具，如台钳，能固定在T形槽上。
6.
Position the slot located in the upper end of replacement grille at the exhaust port and insert edge in the slot.
固定位于排气窗处的更换格删上部末端的槽并且将边插入到槽中。
7.
Remove the screws that secure the instrument panel wire harness trough to the airbag rear mounting bracket.
拆去固定仪表板线束槽到安全气囊后固定托架的螺丝。
8.
a bathroom or lavatory sink that is permanently installed and supplied with water.
固定的安装并提供水的浴室或厕所的水槽。
9.
The valve cover shall be held in place through the use of a single grooved style two-bolt coupling.
阀盖应该通过单个沟槽状双螺栓联结器固定住。
10.
an animal having teeth consolidate with the inner surface of the alveolar ridge without sockets.
长有由内表层无牙槽固定的牙齿的动物。
11.
A groove or flange designed to hold a beveled edge, as of a watch crystal or a gem.
宝石座用来固定斜面的沟槽，如钟表或宝石的
12.
Push the white retaining clips on each side of the memory socket outward.
将存储模块插槽两端的白色固定卡榫扳开。
13.
Study of alveolar ridge augment of modified sandwich techniques retained by implants upon dogs
种植体固定的三明治法增高牙槽嵴的实验研究
14.
Research on Treating Organic Waste Water by Bipolar Packed Bed Cell;
复极性固定床电解槽处理有机废水研究
15.
Half-ring sulcated external fixator treat congenital pseudarthrosis of the tibia
半环槽外固定器治疗先天性胫骨假关节
16.
Evaluation in Efficacy Orthodontic Treatment in Children's Teeth and Alveolar Bone Injuries
儿童牙和牙槽骨损伤的固定正畸处理疗效分析
17.
AN ANALYSIS OF THE FAILURE OF BONDED BRACKETS IN DENTAL FLUOROSIS FIXATION
氟斑牙固定矫治中托槽脱落的相关因素分析
18.
Be sure the dummy club of the bar put into the restrict slot followed by tightening the fastening screws of cover plate
一定要将芯棒的凸台装入限位槽内，拧紧盖板紧固螺丝。