1.
The growth rate can exceed the pull rate and even be negative at a given time.
生长速率可能大于拉晶速率，甚至某一时刻是负值。
2.
EFFECTS OF WITHDRAWAL RATE ON MICROSTRUCTURE AND STRESS RUPTURE PROPERTIES OF A Ni_3Al-BASED SINGLE CRYSTAL SUPERALLOY IC6SX
拉晶速率对Ni_3Al基单晶合金IC6SX凝固组织和高温持久性能的影响
3.
INFLUENCE OF WITHDRAWING RATE TRANSITION ON THE PRIMARY DENDRITE ARM SPACING AND MICROSEGREGATION OF DIRECTIONALLY SOLIDIFIED SINGLE CRYSTAL SUPERALLOY DD3
抽拉速率跃迁对定向凝固单晶高温合金DD3一次枝晶间距和微观偏析的影响
4.
Influence of Increasing Casting Speed of Hypoperitectic Steel Slab on Heat Transfer of Mold
提高亚包晶钢板坯拉速对结晶器传热的影响
5.
Investigation on Rapid Thermal Processing of Czochralski-grown (CZ) Silicon;
直拉硅单晶的快速热处理（RTP）研究
6.
In films Sb could act as the nucleation center and speed up the rate of crystalliza-tion.
在薄膜中,Sb 起着晶核作用,加快析晶速率。
7.
Relationship of Cooling Rate and Grain Sizes in ZL205A Alloy;
ZL205A合金冷却速率与晶粒度的关系
8.
Study on MacPherson-Srolovitz's grain growth rate equation with Monte Carlo simulation
MacPherson-Srolovitz晶粒长大速率方程的仿真验证
9.
The nucleation and growth rate equations of DSP were determined by non-linear regression analysis.
确定了反应结晶和溶析结晶过程中晶体成核和生长速率方程。
10.
Numerical Simulation of Thermal Behavior of Copper Plates for Slab Continuous Casting Mold with High Casting Speed
高拉速板坯连铸结晶器铜板热行为数值模拟
11.
Rapid Growth of ZnO Under High Pressure and Its Raman Spectrum
高压下ZnO晶粒的快速生长及其拉曼光谱研究
12.
Study for Effect Factors of Surface Wave of Molten Steel in Mold for High Speed Slab Casting
高拉速板坯连铸结晶器液面波动影响因素研究
13.
ANALYSIS OF LIQUID FLUX CONSUMPTION MECHANISM FOR SLAB CONTINUOUS CASTING MOLD WITH HIGH CASTING SPEED
高拉速板坯连铸结晶器液态渣消耗机理分析
14.
Undercooling, Grain Refinement and Dendrite Growth Velocity in Cu-Ge Melt Alloys
铜锗合金的深过冷、枝晶生长速率及晶粒细化研究
15.
At first a comprehensive and short review on the characteristics for size growth-rate of crystals is presented.
首先对微晶粒尺寸增长速率的表征进行总结.
16.
The higher temperature, the greater the reaction rate.
反应温度愈高,晶核生长的反应速率愈快。
17.
Grain size had some effect on the rate of crack propagation.
晶粒尺寸大小对裂纹扩展速率也有影响。
18.
Influence of Strain Rate on Grain Refinement by Plastic Deforming;
应变速率对强塑性变形晶粒细化的影响