1.
Design and study of control system for welding roller frame against axial displacement;
防轴向位移焊接滚轮架控制系统的设计与研究
2.
Technology for welding flap helm with lower helm bearing of Changjiang roll-on-roll-off ship No.1
“长江重件1号”滚装船襟翼舵大齿轮与下舵承本体外圈的焊接技术
3.
Frame of front-wheel double-drum component: It is of formed steel welding structure，which is connected with main frame by bolts.
前轮双转鼓组件框架：型钢焊接结构，通过螺栓与主框架连接。
4.
The rear idler brace is then attached along with the two small return rollers to complete the suspension assemblies.
后部的诱导轮支架要和两个小滚轮连接，以此完成悬挂安装。
5.
New Globe-tube Soldering Techoology of Soldering Hollow Globe-Net-Shelf Struct ure;
焊接空心球网架结构球—管焊接新工艺
6.
Microstructures and Mechanical Properties of the Welded Joints in Bogie Frame;
转向架构架焊接接头组织与性能研究
7.
carriage tension spring
滚轮架拉力弹簧 -打字机用
8.
Research on the knurling connection strength of hollow assembled camshaft
中空组合式凸轮轴滚花连接强度研究
9.
A low flat framework that rolls on casters, used by a mechanic working beneath an automobile.
轮脚架在汽车底下工作的修理工使用的、在脚轮上滚动的低平框架
10.
EFFECT OF WHEEL PROFILE ON ROLLING CONTACT BEHAVIOR OF WHEEL/RAIL AND ITS SELECTION
车轮型面对轮轨滚动接触行为影响及选用
11.
Study on Submerged Arc Welding Manufacturing Technique of Agricultural Machinery Cylinder Tube
农业机械中滚筒筒体埋弧焊接制造技术研究
12.
Analysis for the Welded Empty Sphere Joint with Incompletely Filled Groove Defect;
含未焊透缺陷网架焊接空心球节点应力分析
13.
Welding the Carriage Framework Analysis of the Familiar Blemish to the CO_2 Protection;
对CO_2保护焊焊接车身骨架常见缺陷的分析
14.
Welding Defects of Submerged Arc Welding of Box Derrick and the Countermeasures
箱体井架埋弧焊的焊接缺陷及其防止对策
15.
The Exploitation and Research on the Anti-axial Drifting of the Intelligent Roller Bed System;
智能防轴向窜动滚轮架系统的研究与开发
16.
The Development about Framework and Assembling & Adjusting System of the Large Diameter Measurement System with Idler Wheels;
大直径多滚压轮测量仪支架及装调系统研制
17.
carbide-tipped pulley grooving tool
硬质合金焊接皮带轮切槽车刀
18.
Welded steel type cranked link mill chains and chain wheels
GB/T15390-1994工程用钢制焊接弯板链和链轮