1.
multi-functional slitting machine for corrugated paperboard
多功能瓦楞纸板切槽机
2.
drunken saw
【机】切[开]槽锯
3.
groover concrete cutter
开槽式混凝土切削机
4.
tenoning and trenching machine
榫头切削和开槽两用机
5.
segment notching press
整流子片切槽专用压力机
6.
The groove so cut.
榫槽这种切割的凹槽
7.
Study on the Failed Mechanism and Experiment of Spiral Notch-holes Blasting;
螺旋切槽孔松动爆破力学机理及试验研究
8.
Research on the NC System of the Machine for Notching Fracture Splitting Notch in the Connecting Rod by Laser;
连杆裂解槽激光切割机床数控系统研究
9.
Study on the Mechanism of Notched Directional Splitting Controlled Blasting by Dynamic Photoelastic Method;
切槽定向断裂控制爆破机理的动光弹研究
10.
Analysis on cogging torque in axial field flux-switching permanent magnet machine
轴向磁场磁通切换永磁电机齿槽转矩分析
11.
Trim or remove excess sealant film in the rear main cap oil pan gasket groovDO NOT remove the sealant inside the rear main cap slots.
修整或清除后主盖机油底壳垫圈凹槽中过多的密封剂薄膜。切勿清除在后主盖槽中的密封剂。
12.
The machine head can be adjusted for angle cutting and milling flutes to have the precise angles and round connecting piece.
该机头可左右调整斜切或铣槽，角度准确，管子接口完美省工。
13.
Study on Measuring Methods and Chip Breaking Mechanism of 3D Non-Uniform Groove Cutting Tools;
三维复杂槽型车刀片测量方法及切屑折断机理的研究
14.
Study on the Theory and Application of Cut-In Disrepair with 3D Complex Groove Wave-Edge Milling Insert
三维复杂槽型铣刀片切入破损机理及其应用的研究
15.
Analysis of Causes of Roll-cut Inefficiency on Driving-drum Spinle Key-slot of DSP160/1000 Type Belt Conveyer
DSP160/1000带式输送机传动滚筒轴键槽滚切失效成因分析
16.
Water fountain: The metal trough on an offset press which holds the damping solution.
水槽:在柯式印刷机上，盛载水槽液的槽。
17.
A trough or flume used in washing ore.
槽洗机洗矿用的水槽或流槽
18.
channel-cutting, opening or closing machines, for shoemaking
开槽、破槽或合槽机,制鞋用