1.
The Quality Control of Pressure Vessel to Take Over the Welding Process of Welding
压力容器接管焊接过程中焊接质量的控制
2.
assembly of nozzle necks to vessel walls
容器壁同接管的装配
3.
height of nozzles and M.H. from outside vesse
接管与人孔离容器外侧高度
4.
The prediction of the burst pressure of pressure vessels with miter pipe
轴向斜接管内压容器爆破压力的预测
5.
4"H.T. Hose Connection which easily attaches to an outside hose bibb or to the drain connection on a water heater.
软管连接，容易连接到外置软管水龙头或热水器的排放接头。
6.
2 All welds for nozzles and manways shall be full penetration through the vessel wall.
接管和人孔的焊缝应为穿过容器壁的全熔透。
7.
COMPUTER MANAGEMENT SYSTEM OF WELDING PROCEDURE CARD FOR PRESSUER VESSEL
压力容器焊接工艺卡的计算机管理系统
8.
Limit Analysis of Pressure Vessels with Pad Reinforcement under In-plane Moment on Nozzles;
接管纵向弯矩作用下带补强圈容器的极限分析
9.
A Study of Limit Load for Cylindrical Shells with Reinforcement Pad under Nozzle Moment;
接管弯矩作用下容器补强结构极限载荷的研究
10.
Investigation on the Limit and Burst Pressures for the Vessels with Nozzle;
带接管压力容器极限压力及爆破压力的研究
11.
Stress analysis of Opening Tubing Connection Zone for High Pressure Vessels Based Finite Element;
基于有限元的高压容器开孔接管区应力分析
12.
Evaluation on the Stress Strength at the Junction Area between the Cylinder of an Internal Pressure Vessel and Its Big Nozzle
内压容器筒体与大接管相贯区的应力强度评定
13.
Limit Analysis for Cylindrical Shells with Opening-reinforcement under In-plane Moment
接管纵向弯矩下带补强圈容器结构的极限分析
14.
holes in joints of welded vessels
焊接容器接头处的孔
15.
Analysis on Connection Mode of Measuring Capacitance and Dielectric Loss of Transformer Condenser Bushing
变压器电容式套管电容量及介损测量接线方式分析
16.
capacitor changeover contactor
切换电容器式接触器
17.
The gaseous hydrogen storage vessels and associated piping shall be electrically bonded and grounded.
气态氢储存容器和附属管道应当用导线连接在一起，且接地良好。
18.
an obsolete kind of container used for distillation; two retorts connected by a tube.
用来蒸馏的陈旧的容器；两个蒸器用管子连接起来。