1.
BREAK CAUSE ANALYSIS FOR ER70S-6 WIRE BAR IN DRAWING AND ITS CONTROL
ER70S-6盘条拉拔断裂的原因分析及控制
2.
Cause analysis of ER70S -6 wire rod drawing fracture
ER70S-6盘条拉拔断裂原因分析
3.
Fracture Analysis of Welding Wire Coil ER50-6 Breaking during Drawing
ER50-6焊丝用盘条拉拔断裂原因分析
4.
Analyse and Research the Reason about Draw-breaking of Middle & Low Carbon Steel Wire;
中低碳钢丝拉拔断裂影响因素分析及研究
5.
Drawing fracture cause analysis of wire rod for spiral ribbed pre-stressed steel wire
螺旋肋预应力钢丝用盘条拉拔断裂原因分析
6.
Fracture Reasons and Control Measures of 77MnA High Carbon Steel Wire
77MnA高碳钢盘条拉拔断裂原因及控制措施
7.
Drawing fracture analysis of 65 steel wire and wire rod production process improvement
65钢丝拉拔断裂分析与盘条生产工艺改进
8.
Cause Analyses on Brittle Fracture of 82B Wire Rod;
82B高碳钢盘条拉拔脆断的原因分析
9.
Wire: usually produced from hot-roiled rod by drawing; smaller than 4mm in diameter usually with a round section.
线材--一般用热轧细棒材拔拉而成，:直径小于4mm，横断面一般为圆形。
10.
The drawing stress increased with the speed rise at low speed.
在低速拉拔时,拉拔应力随拉拔速度的增加而增大。
11.
A forcible extraction.
拔出，拉出用力拔出或抽取
12.
bright-drawn bar
冷拉光条，光亮冷拔钢条
13.
Puller Set—C-293-PA
拉拔器套件—C-293-PA
14.
pluck or pull at with the fingers.
用手指用力地拉或拔。
15.
Distributor Bushing Puller C-3052
分电器套管拉拔器C-3052
16.
Cylinder Liner Puller VM, 1001
汽缸套拉拔器VM, 1001
17.
Transverse crack analysis of SWRH 82B wire rod drawing
SWRH82B盘条拉拔横裂纹分析
18.
Hold puller screw and tighten puller nut until bushing is remove
握紧拉拔器螺栓，拧紧拉拔器螺母，直至拆下衬套。