1.
A formula for accurate calculation of the influence of insulation eccentricity on the coaxial capacitance, characteristics impedance and insulation resistance of RF coaxial cables were deduced by the electrical axis method.
本文利用电轴法推导出精确计算绝缘偏心时同轴电容、性阻抗和绝缘电阻的计算公式。
2.
Analysis of Axial Stiffness of Permanent Magnet Bearings by Using the Equivalent Surface Currents Method
基于分子电流法轴向永磁轴承轴向刚度的分析
3.
Calculation Method Research of the Interference Fit for High Speed Motorized Spindle Bearings
高速电主轴轴承配合过盈量的计算方法研究
4.
Research on Analysis of Shaft Bending Accident and Straightening Method for Turbo-Generator;
汽轮发电机组弯轴事故分析及直轴方法研究
5.
Numerical Method for Capacitance Matrix of Coaxial Cables of Finite Length
有限长同轴电缆电容的数值计算方法
6.
Study on the Design Method of Parameter for AMB Controller
电磁轴承控制器参数设计方法的研究
7.
Analysis of the Reasons of Abrasion of Electric Motor Crankshaft and How to Repair;
电动机轴颈磨损原因分析及修理方法
8.
Practical approach to hydrophobic recovery of the sealing heater for self-equipped thermal plants
自备热电厂轴封加热器疏水回收方法
9.
STUDY ON DATA PROCESSING METHODS FOR COAXIAL-THERMAL-COUPLE HEAT-FLUX SENSOR
镀层式同轴热电偶数据处理方法研究
10.
Assessment of a simple visual method of cardiac electric axis
心电轴改良目测法及其临床应用评价
11.
Discussion on the replacement of the ESP ceramic shaft in operation method
运行中更换电除尘器瓷转轴方法探讨
12.
Measurement methods for 120-channel submarine coaxial cable carrier telephone equipment
GB/T13429-1992120路海底同轴电缆载波电话设备测试方法
13.
Measurement for 24-channels submarine coaxial cable carrier telephone equipment
GB/T13425-199224路海底同轴电缆载波电话设备测试方法
14.
Research of Milling Force Supervisory Control Method Based on Spindle Motor Current;
基于主轴电机电流的铣削力监控方法研究
15.
An Experiment on Resistance Strain Gage to Pit Test for Electromechanical Main Bearing;
用电阻应变片检测电机主轴运行故障的方法
16.
Design Method for High-speed Motorized Spindle Motor Based on Analysis of Harmonics
基于谐波分析的高速电主轴电机设计方法研究
17.
Calculation of inductances for bearingless switched reluctance motors with different finite element formulations
三维有限元法求解无轴承开关磁阻电机电感
18.
Using Electric Brush Electroplate to Repair Grinding Crack of Eectromotor rotor axis
利用电刷镀方法修复电动机转子轴磨痕