1.
Fracture analysis of the liner bolts used for φ5.03 m×6.4 m ball mill
Φ5.03 m×6.4 m球磨机端衬板螺栓断裂分析
2.
Reason Analysis of Bolt Breakdown Failure in Steel Ball Pulverizer Body and the Sheath Plate Reformation
钢球磨煤机筒体断螺栓原因分析及衬板改造
3.
shock absorber eye bolt sleeve
减震器有眼螺栓衬套
4.
draw-bar carrier bolt
牵引杆托(板)螺栓
5.
follower stud and unt
从动板柱螺栓及螺母
6.
Bushing Retainer To Axle Attaching Bolts
衬套扣环与车轴接合螺栓
7.
Bushing Retainer To Suspension Cradle Attaching Bolts
衬套扣环与悬吊架接合螺栓
8.
Remove the bolts and lift the pan off the manifolDiscard the gasket.
拆下螺栓并举高盘脱离歧管。扔掉衬垫。
9.
Hold puller screw and tighten puller nut until bushing is remove
握紧拉拔器螺栓，拧紧拉拔器螺母，直至拆下衬套。
10.
Design of Based on ANSYS Tunnel Lining Trolley Gantry Frame Bolt
基于ANSYS的隧道衬砌台车龙门架螺栓副设计
11.
"Bolts,screws & nuts"
"螺栓,螺丝及螺帽"
12.
Install the bolts attaching the end cap to the front fender.
安装连接末端端盖到前挡泥板的螺栓。
13.
The wall panels were bolted to the concrete foundation.
墙壁镶板用螺栓安装在混凝土地基上。
14.
Study on tension and block shear behavior of bolted single angle-gusset plates
单角钢螺栓连接节点板拉剪性能研究
15.
The enterprise shanghai tongsheng trade co., ltd. offers among other things Wall screws and Chipboard screws.
为您提供关于切削板螺栓或墙螺丝钉的信息。
16.
Inspect crankshaft, flexplate/flywheel and bolts for damagTighten to correct torque
检查曲轴、活动板/飞轮和螺栓是否松动。拧紧螺栓以校正扭力。
17.
One of several component pieces that are fitted into a diestock to cut threads on screws or bolts.
铆头模一种组成切削螺栓上的板牙板手的部件
18.
Loosen but do not fully remove the four bolts that attach the stabilizer bar bushing retainers to the rear axle brackets.
松开但不完全拆卸接合稳定杆衬套扣环与后车轴支架的4支螺栓。