1.
Condensate will leave marks on the preform surface.
露水会遗留痕迹在瓶坯的表面上。
2.
There will be a sprue at the bottom of the preform of no more than 5 mm.
瓶坯底会留有不超过5mm长的水口
3.
In the injection stretch blow moulding process, injection moulding machine is used to make the preform.
注拉吹工艺先用注塑机注出瓶坯。
4.
The king of preform is that of 5-gallon (19-litre) bottle used in drinking water machines. It weighs between 650 and 750g.
瓶坯的皇者是5加仑(19公升)的饮水机瓶子的瓶坯，重量由650g至750g不等。
5.
Bottle weight, which is the same as preform weight, is essentially non-adjustable.
瓶子的重量(壁厚)相当于瓶坯的重量，而后者基本上不能调整。
6.
Most preform moulds are rectangular and are longer than they are wide.
大多数的瓶坯模具呈长形，就是长度比阔度大。
7.
Cooling time dominates cycle time in thick-wall moulding like preform moulding.
属厚壁注塑的瓶坯，冷却时间支配着周期时间。
8.
Design of Injection Mould with Wedge-shaped Plate Typing and Hot Runner System for Mineral Water Bottle Parison
楔形导板分型矿泉水瓶坯热流道注塑模设计
9.
A method of detecting defects of PET bottle base mouths based on electro-optical devices
一种基于光电设备检测PET瓶坯口缺陷的方法
10.
Multi-cavity preform moulds do not use the cold runner design. An often-used design for the runners is hot plate design.
多腔的瓶坯模具都不采用冷流道的。较简单的流道是热板设计。
11.
cooling the preform mould by chiller instead of water tower could reduce the cycle time by 10%.
以冰水冷却瓶坯模具比水塔水冷却缩短冷却时间10%
12.
In the second stage, room temperature preforms are reheated, stretched and blow moulded into bottles, in a reheat stretch blow moulding machine.
第二步将室温的瓶坯再加热后，拉吹成为瓶子，是在另一台“再加热，拉吹机”上完成。
13.
Plastic shrinks during cooling. Holding packs more material in to take up the shrunk space so the preforms are without sink marks.
在冷却时间内，塑料不断收缩，而保压填补收缩了的空间，使瓶坯饱满，不会下陷。
14.
hot-water bottle of porcelain or china
瓷或白坯瓷制热水瓶
15.
Steel blank for seamless gas cylinder
GB13447-1992无缝气瓶用钢坯
16.
cruet ,of porcelain or china
调味瓶,瓷或白坯瓷制
17.
bottle of ceramic other than porcelain or china
除瓷或白坯瓷外的陶瓶
18.
Precise preform loading system in order to minimize failure rate.
高可靠性的进坯、上坯、出坯系统、使吹瓶机故障率降到最低。