1.
The Basic Research of Laser Cladding Technology for the Universal Joint Fork's Repair;
万向接轴叉头激光堆焊修复技术的基础研究
2.
"The four arms of the spider, known as trunnions, are assembled into bearings in the ends of the two shaft yokes."
万向节十字轴的四个轴颈叫做万向节十字头,分别装在两个万向节叉顶端的轴承中。
3.
flange crossing-transmission shaft universal joint
凸缘叉-传动轴万向节
4.
The Analysis of Fracture for the Flat Head of Universed Joint
1150初轧机万向接轴扁头断裂分析
5.
"When the two shafts are at an angle to each other, the bearings in the yokes permit the yokes to swing around on the trunnions with each revolution."
当两轴相互处在同一角度上,主动轴转动时万向节叉上的轴承使万向节叉绕万向节十字轴摆动。
6.
Hook's coupling
胡克接头，万向接头
7.
external pressure single type axial expansion joint
外压单式轴向伸缩接头
8.
radial bearing upper drive sub
上部径向轴承传动接头
9.
radial bearing lower drive sub
下部径向轴承传动接头
10.
"The driving shaft causes the spider to rotate, and the other two trunnions of the spider cause the driven shaft to rotate."
主动轴使万向节十字轴转动,另外两个万向节十字头使从动轴转动。
11.
The dynamic virtual analysis of the tripod sliding universal joint
三叉杆滑块式万向联轴器动力虚拟分析
12.
Contact problems for needle bearing of cardan shaft in high speed EMUs
高速动车组万向轴滚针轴承接触问题研究
13.
Virtual Design System Research and Executer of Tripod Universal Joint Based on Application of VRML;
基于VRML的三叉杆式万向联轴器虚拟设计系统的研究与实现
14.
The Inside Ball Kinematic Simulation Analysis of the Tripod Sliding Universal Joint Based on ADAMS
基于ADAMS的三叉杆滑块式万向联轴器的内球运动仿真分析
15.
It is recommended to make marks on the yolks and the cardan shafts so that you can assemble them correctly.
当安装万向传动装置时建议在万向节叉和传动轴上做明显的记号，以便能够正确地安装。
16.
Research the Bearing Capacity of Universal-joint Spindle in 170 Piercing Mill Main Transmission System
170穿孔机主传动系统万向接轴承载能力分析
17.
The two-section propeller is supported by a center bearing and coupled together by universal joints.
两段传动轴之间有一个中间支承轴承,并由万向节连接。
18.
Align mark on the rear link yoke and universal joint to the mark on the transfer case yoke.
将后连接轴轭和万向节上的标志与传动箱轴轭上的标志对准。