1.
Strength Analysis and Life Prediction of a Turboprop Gas Turbine Rotor;
某涡浆发动机涡轮转子强度与寿命计算
2.
Virtual Manufacturing of TMP Rotor Based on UG CAM
基于UG CAM的涡轮转子虚拟加工(英文)
3.
Therefore, the properties of these two kinds of materials were considered.
全面研究了此涡轮转子耦合振动的特性。
4.
Parametric Design, Analysis of Turbine Rotor Structures and Software Integration;
涡轮转子结构参数化设计、分析及其软件集成
5.
Investigation on Friction Welding of the Low Pressure Turbine Rotor and Shaft;
某低压涡轮转子与轴的摩擦焊工艺研究
6.
Analysis of Static Strength and Fatigue Reliability of High-Pressure Turbine Rotor System
某高压涡轮转子系统静强度及疲劳可靠性分析
7.
Studies of Flow and Heat Transfer Characteristic on the HPT Blade Tip
高压涡轮转子叶片端面的流动与换热特性研究
8.
The strength and service life verification tests of a newly designed third stage turbine rotor and disc of Type A and Type A-1 engine
甲型和甲-Ⅰ型发动机全新设计的第Ⅲ级涡轮转子及涡轮盘强度与寿命考核试验
9.
The coupling vibration behaviors of a particular turbine rotor have been analyzed.
本文分析研究了特型涡轮转子多重耦合振动系统的固有特性。
10.
counter rotating turbine
正反转双转子涡轮机
11.
bucket for stators or rotors of hydraulic turbines
水力涡轮机定子或转子戽斗
12.
Dynamic balance test should be carried out to the rotor of the turbocharger.
涡轮增压器转子应进行动平衡试验。
13.
Fault Research of Turbo Supercharger Rotor Mass Imbalance
涡轮增压器转子质量不平衡故障分析
14.
integrally-forged impulse wheel
(涡轮机) 整锻冲动式转轮
15.
Research of the Solution Method on the Critical Speed of Turbo Supercharger Rotor
涡轮增压器转子临界转速的求解方法研究
16.
The Calculation of Rotor Negative-sequence Eddy Current Field of Turbogenerator by the Finite Element Method
汽轮发电机转子负序涡流场的有限元计算
17.
The Visualization of Axial Interval Adjustment between Stator and Rotor of Turbodrill
涡轮钻具定转子轴向间隙调整的可视化研究
18.
Whirling Characteristics of High Speed Rotors in Flywheel and CMG
飞轮和控制力矩陀螺高速转子的涡动特性研究