1.
Numerical Simulation and Experimental Study on Air-Condition System with Radiation Ceilings;
冷却顶板空调系统的数值模拟与实验研究
2.
CFD Investigation for a System with Cooled Ceiling and Displacement Ventilation;
冷却顶板加置换通风空调系统的CFD研究
3.
The Experiment Research of Combined Cooling Ceiling and Displacement Ventilation System;
冷却顶板置换通风复合空调系统的实验研究
4.
The Simulation Research of The Dew Point Temperature for Displacement Ventilation with Cooling Ceiling
置换通风与冷却顶板房间露点温度的模拟研究
5.
Dynamic Simulation Research on Condensation for Displacement Ventilation with Cooling Ceiling
置换通风与冷却顶板结露问题的动态仿真研究
6.
Research on the Distributive Proportion of Cooling Load for Chilled Ceiling System Combined with Displacement Ventilation
冷却顶板—置换通风空调系统中冷负荷分配比例研究
7.
Experiment and Simulation of System Combining Displacement Ventilation with Cooling Ceiling with High Long Wave Transimitance Film;
加装长波高透过性薄膜的冷却顶板/置换通风系统实验与模拟
8.
Study on Dynamic Energy Analysis of the Combined Cooling Ceiling and Displacement Ventilation System;
置换通风和冷却顶板复合系统动态能耗分析研究
9.
Numerical Simulation and Analysis in Displacement Ventilation System with the Influence of Cooled Ceiling and Solar Radiation;
冷却顶板和太阳辐射对置换通风系统影响的模拟与分析
10.
The Simulation Research of the Thermal Environment and Dehumidification for Displacement Ventilation with Cooling Ceiling System
置换通风与冷却顶板空调系统热环境与除湿的模拟研究
11.
Experimental Research on Thermal Environment and Thermal Comfort of the Chilled Panel in Heating Mode
冷却顶板供热工况室内热环境及人体热舒适实验研究
12.
Experimental Study on Cooling Ceiling Air-conditioning System Covered and Airproofed with the Film Whose Long Wave Transmittance(LWT) is High
加装长波高透过性薄膜的冷却顶板空调系统的实验研究
13.
Methodology of avoiding condensation and downdraft in displacement ventilation plus cooling ceiling system
置换通风加冷却顶板系统避免结露和下降气流的方法
14.
orificing the coolant
对冷却剂加孔板节流
15.
"After the Block is cleaned, inspect it for cracks, especially in the cylinder walls, top, water jackets, and main-Bearing webs."
气缸体清洁之后,检查有无裂痕,尤其是气缸壁、顶部、冷却水套和主轴承腹板。
16.
On most automotive battery grids, cooling is required in the top gate area and in the center of the mold only.
绝大部分汽车蓄电池板栅尺需要在顶部浇口部分和模具的中心冷却就可以。
17.
The Analysis on Control Strategy of Cooling Rate for Plate Accelerated Cooling
中厚板轧后冷却冷速控制策略的分析
18.
Experiments and study on the Cooling Property of Quenching Liquid in the Plate Cooling Apparatus Ⅰ;
板式冷却装置Ⅰ淬火液冷却性能实验与研究