1.
Microstructure Simulation of Unidirectional Solidification Based on Dendrite Envelope Tracking Method;
基于枝晶包膜跟踪法的单向凝固微观组织模拟研究
2.
Experimental Study on RC Two-way Slabs Strengthened in One-way Method;
钢筋混凝土双向板单向加固技术的试验研究
3.
Study on Bending Capacity of Reinforced Concrete Slabs Strengthened with FRP Sheet;
FRP片材加固钢筋混凝土单向板受弯性能研究
4.
Directional solidification and single crystal will be the development direction of the casting microstructure simulation.
铸件微观组织模拟研究向定向凝固及单晶方面发展。
5.
SOLIDIFICATION PHASE SELECTION IN DIRECTIONALLY SOLIDIFIED Ti-(44%-54%)Al ALLOYS
定向凝固Ti-(44%—54%)Al合金的凝固相选择
6.
The Effect of Directional Solidification on Macrograph Structure of AZ31 Mg Alloy
定向凝固对AZ31镁合金凝固组织的影响
7.
COMPUTER DETECTION AND ANALYSIS CALCULATION OF THERMAL PARAMETERS DURING DS OF SINGLE CRYSTAL SUPERALLOY
单晶高温合金定向凝固热参数的计算机检测及热分析计算
8.
Finite Element Analysis of Reinforced Concrete One-way Slab Strengthened with CFRP;
碳纤维布（CFRP）加固钢筋混凝土单向板的有限元分析
9.
Melt Spinning Processing Equipment and the Structure of Mg-5%Zn Alloy Produced by RSP;
单辊快速凝固装置与Mg-5%Zn合金快速凝固组织
10.
Numerical Simulation of the Process of Vertical and Directional Solidification of Large-size Steel Ingot;
大型垂直定向凝固钢锭凝固过程数值模拟
11.
vertical single-pass condenser
立式单向通路冷凝器
12.
The SME of the sample made by OCC is better than the ones made by directional casting,and it can preponderate over the single crystal CuAlNishape memory alloys.
热型连铸试样记忆性优于定向凝固,并且超过单晶的CuAlNi形状记忆合金的记忆性。
13.
INFLUENCE OF WITHDRAWING RATE TRANSITION ON THE PRIMARY DENDRITE ARM SPACING AND MICROSEGREGATION OF DIRECTIONALLY SOLIDIFIED SINGLE CRYSTAL SUPERALLOY DD3
抽拉速率跃迁对定向凝固单晶高温合金DD3一次枝晶间距和微观偏析的影响
14.
condenser ,fixed , ceramic dielectric, single layer
单层陶瓷介质固定冷凝器
15.
Solidification of Undercooled Ni_(54.6)Pd_(45.4) Alloy
Ni_（54.6）Pd_（45.4）单相合金的深过冷凝固
16.
heat liberated by a unit mass of liquid at its freezing point when it solidifies.
在凝固点时一单位质量的液体凝固的时候放出的热。
17.
A Study of Temperature Gradient in Liquid Phase for Double-zone Heat Directional Solidification
双区加热定向凝固液相温度梯度研究
18.
Microstructure and Phase Selection in the Unidirectional Solidification of Zn-Cu Peritectic Alloy;
Zn-Cu包晶合金定向凝固组织及相选择