1.
Studies on Resistive Wall Instability Driven by Plasma Flow in a Slab Model;
平板模型中流驱动电阻壁不稳定性的研究
2.
Simulation Analysis on Continuous Leakage and Diffusion of LPG Based on Slab Model
平板模型对液化石油气连续泄漏扩散模拟分析与探讨
3.
turning-over board
翻箱板，造型平板，底板
4.
Simulation and Control of Intermediate Temperature Planar Solid Oxide Fuel Cell Stack;
中温平板型SOFC电堆的模拟与控制
5.
Mechanical Analysis of the Model Element Outside the Diffuent Surface in Parallel Flat Compression;
平行板压缩分流面外侧模型单元的力学分析
6.
AN INVESTIGATION ON THE TENSION ANALYTICAL MODEL OF STEEL PLATE WITH STAGGERED BOLT HOLES
交错孔洞平板螺栓连接受拉分析模型研究
7.
Research on the stress-strain model of compensated shrinkage concrete flat plate
补偿收缩混凝土平板构件的应力—应变模型研究
8.
The numerical simulation on heat transfer performance of rectangular micro channel plate heat pipe
微小型矩形槽道平板热管传热性能的数值模拟
9.
Process Control Model for the Rolling and Levelling of Strip
板带轧制AGC和平整过程的工艺控制模型
10.
In this paper, critical technology and forming process of platform plate mould design are stated by way of platform plate products.
以大型平台板产品为例,介绍了矿用大型平台板模具设计中的关键技术及成形工艺。
11.
moulding board used in the preparation of sand moulds
造型平板,用于制备砂型
12.
Improved Plane Fin Model Calculation for Heat Dissipating Capacity in Low-temperature Hot Water Floor Radiation Heating System;
低温热水地板辐射供暖系统改进型平面肋片模型计算法
13.
card of pattern
装有几个模型的型板
14.
plate solar heater
太阳能平板型集热器
15.
The Establishing of Stress Model and Error Analysis about the Flat Brake Tester;
基于平板制动试验台的数学模型的建立及其误差分析
16.
Experimental Investigation of Complex Eddy Viscosity Modeling in Turbulent Boundary Layer with Periodic Blow/Suction Disturbance
加入周期吹吸扰动的平板湍流边界层复涡黏模型实验研究
17.
Building a Dynamic Equilibrium Model of Clinical Platelet Usage in Urumqi Blood Center
乌鲁木齐市血液中心临床血小板用量动态平衡模型的建立
18.
Dynamic and sound transmission character excited by plane sound waves based on zig-zag model of sandwich plate
基于Zig-Zag模型夹层板动力与平面波作用下声传输特性研究