1.
Site mark the required position, e.g. 10cm below the underarm point at B.
定出所需位置并标记号,如B处,腋下10cm处。
2.
To move a point, click the point, and then drag to the location you want.
要移动某点，请单击该点，然后拖动到所需位置。
3.
Disc drive: The mechanism which rotates the magnetic disc and positions the reas /write head(s) at he desired location.
磁碟驱动器:转动磁碟，把读写头移到所需位置的机械结构。
4.
To move a path, click a line segment, and then drag to the location you want.
要移动路径，请单击某个线段，然后拖动到所需位置。
5.
A required expression was not found at the expected location.
未在预期位置找到所需的表达式。
6.
Decide where the dart has to be rested and which dart is unwanted.
决定省道所处的位置以及哪个省是不需要的。
7.
A required codec is missing and must be downloaded from the following location.
缺少所需的编解码器，必须从以下位置下载。
8.
To copy the needed files from the selected location, click OK.
要从选定的位置复制所需的文件，请单击“确定”。
9.
The time required for the shock to travel to its final position is known as the lag time.
冲波移动到最后位置所需的时间称为滞后时间。
10.
Supplies the required 5 volt power source to the crankshaft position sensor, camshaft position sensor, MAP sensor and throttle position sensor.
向曲轴位置感应器、凸轮轴位置感应器、MAP感应器以及节气阀位置感应器提供所需的5伏电压。
11.
Use the mode dial to select the desired mode, and press the updown buttons to select the desired setting where applicable.
使用模式盘选择所需模式时,请按向上向下按钮直至您所需的设置位置。
12.
To set a tab stop, choose the type you want, and then click the ruler where you want to add the tab stop
设置制表位的方法是: 先选择所需类型，然后按需要添加制表符的位置在标尺上单击
13.
Note that all of the following mic placement positions are my starting positions.
需要注意的是，以下提到的所有麦克的摆位都是指起始位置。
14.
The Discover Tour could not be located. Please indicate the location of the required files below:
无法定位“探索教程”。请在下面指出所需文件的位置:
15.
The central knob has fewer positions and all you need to do is to switch it to the quantity you want to measure.
中间的旋钮只有几个位置，您所需要做的，就是选择所需要的测量功能。
16.
It may take a day or two for the @policemen@ in your body to locate all the intruders.
人体内的“警察”需要一两天的时间来查找“入侵者”的所在位置。
17.
Cursor: Moveable indicator on a video display screen to show a location as instructed by the operator.
光标:在影像显示荧光屏上可移动的标志。它指出操作员所需的位置。
18.
A Binding agreement is created upon acceptance by the student of the offer of a place at the school and the payment of the Course tuition.
学生接受本校所给位置,即达成有约束力的协议,并需缴付学费。