1.
The Influence Analysis on Precision of Press Caused by the Diameter Deviation of the Crank Supporting Neck
曲轴支承颈的轴径误差对压力机精度影响分析
2.
upper center crankshaft bearing
曲轴主轴承上中轴瓦
3.
Structure Optimization for Hydrostatic Supporting Bush of Crank Shaft and Rod Type Hydraulic Motor
曲轴连杆式液压马达静压支承连杆瓦结构优化
4.
Exact Solution for Axisymmetric Bending of Functionally Graded Circular Plate Under Elastically Supported Boundary Condition
弹性支承功能梯度圆板轴对称弯曲问题精确解
5.
The feed holes for the crankshaft main bearings.
曲轴主轴承进入口。
6.
Crankshaft and main bearings service
曲轴和主轴承的维修
7.
pto bearing support
动力输出轴支持轴承
8.
In the engine, oil is supplied to crankshaft and camshaft journals rotating in their supporting bearings.
在发动机里，机油被供应到旋转在其支承轴内的曲轴和凸轮轴轴颈上。
9.
COMBINED TORSIONAL AND FLEXURAL BUCKLING OF A THIN-WALLED BAR ON ELASTIC SUPPORTS UNDER AXIAL LOADS
多弹性支承薄壁杆在轴向力作用下的弯扭联合屈曲
10.
Modeling for Rotor System of AC Magnetic Bearing Electric Spindle;
交流磁轴承支承电主轴转子系统建模
11.
Pilot bearing in crankshaft. The pilot bearing in the crankshaft is usually either a Bushing or a Ball bearing.
曲轴上的导向轴承:曲轴上的导向轴承一般或者是轴瓦,或者是球轴承。
12.
engine supporting arm
发动机曲轴箱支座臂
13.
Most Bearings support rotating shafts against either transverse (radial) or thrust (axial) loads.
大多数轴承都支承径向或轴向负荷的转轴。
14.
Excessive friction in strut upper bearing
支柱上轴承磨损过度
15.
The carriage is supported on guide shafts.
托架支承在导轴上。
16.
MAIN BEARING JOURNAL DIAMETER (CRANKSHAFT REMOVED)
主轴承颈部直径（曲轴已卸去）
17.
Optimization Design of Bearing for Internal Combustion Engine Considering Crankshaft Strength;
计及曲轴强度的内燃机轴承优化设计
18.
Analysis of Crankshaft Bearing Lubrication Based on ADAMS-ENGINE
基于ADAMS-ENGINE的曲轴轴承润滑分析