1.
The job of the timing belt is to turn the camshaft(s) at exactly 1/2 the speed of the crankshaft while maintaining a precise alignment.
正时皮带的工作是:当保持精准定位时调整凸轮轴的运转速度为曲轴速度的一半.
2.
These sensors establish ignition and fuel injection timing, and monitor crankshaft speed variation.
这些传感器（的信号）来对点火、燃油喷射定时和曲轴速度变化监控。
3.
The camshaft rotates in phase with the crankshaft, but at half its speed.
凸轮轴和曲轴协调旋转, 但速度仅是曲轴的一半。
4.
High Speed Grinding with CBN Grit Wheel for Camshaft Manufacturing of Engine
发动机曲轴凸轮轴CBN高速磨削加工
5.
The pinion gear is on the same shaft as the motor armature and rotates at the same speed.
小齿轮如马达电枢般在同一曲轴上，且以相同的速度转动。？
6.
Judgement and Application of Ignition Moment During Engine Startup Period Based on Crankshaft Transient Acceleration Analysis
基于曲轴瞬时加速度分析的发动机启动过程着火判定与应用
7.
Study on Fatigue Strength of Nodular Graphite Cast Iron Crankshaft of Locomotive High Speed Diesel Engine
内燃机车用高速柴油机球铁曲轴疲劳强度的试验研究
8.
The ratio of the crankshaft to the revolutions of the camshaft is 2∶1.
曲轴的转速与凸轮轴的转速之比是2∶1。
9.
Meanwhile, the fracture was accelerated due to the uneven surface hardness and the unreasonable distribution of the hardening layer on the crankshaft, and the bad lubrication condition in service.
同时轴左颈表面硬度不均匀、淬硬层分布不甚合理，工作过程中润滑条件差，加速了曲轴的断裂。
10.
Optimization Design of Bearing for Internal Combustion Engine Considering Crankshaft Strength;
计及曲轴强度的内燃机轴承优化设计
11.
The Performance Analysis of Diesel Crankshaft and the Research for Calculation Method of Crankshaft Fatigue Strength;
柴油机曲轴性能分析及曲轴强度计算方法研究
12.
Analytical Investigation on Strength and Main Bearing Lubrication of CA4D32 Diesel Engine Crankshaft System Based on a Simulation Technique;
柴油机曲轴轴系强度和主轴承润滑仿真研究
13.
Analysis of Inspection and Measuring Method for 120° Distributing Angle Errors of Crankshaft Crankpins
曲轴曲拐120°角度误差检测方法分析
14.
Influence of Training with Secondary Load on Bending Fatigue Strength of Cranksh aft
次载锻炼对曲轴弯曲疲劳强度的影响
15.
points of mean axial fluid velocity
平均轴向流体速度点
16.
average angular velocity of main shaft of machinery
机械主轴的平均角速度
17.
piezoelectric triaxial accelerometer
压电式三轴加速度计
18.
Numerical Simulation of Vibration and Fatigue on Diesel Engine of High-speed Locomotive;
提速机车柴油机曲轴振动与疲劳仿真