1.
counter crankshaft rotation
反曲轴转动方向的转动
2.
A camshaft driven by a chain or belt turns in the same direction as the crankshaft.
凸轮轴被链或者带驱动，使其朝着曲轴相同的方向转动。
3.
But a camshaft driven directly by the crankshaft gear turns in the opposite direction.
但是凸轮轴被曲轴齿轮直接驱动，其将在相反方向上转动。
4.
Shaft with curved arrow showing direction of rotation.
带指示旋转方向的弯曲箭头的轴。
5.
A shaft that turns or is turned by a crank.
机轴用曲柄来转动的轴
6.
The minimum amount of oil is reached when marker dot A is brought close to needle bar crank 3 by turning the adjust pin in direction B.
调详销刻点A从图的位置向B方向转动，转动到接近针杆曲轴3时，油量最小。
7.
Torsional vibration of crankshaft systems--Measurement and evaluation method
GB/T15371-1994曲轴轴系扭转振动的测量与评定方法
8.
The maximum amount of oil is reached when marker dot A is brought to the position just opposite from the needle bar crank 3 by turning the adjust pin in direction C.
从图上所示的位置向C方向转动，当转到与针杆曲轴3的正对面的位置时，油量为最大。
9.
steering clutch release crank axle
转向离合器开关曲柄轴
10.
Bi-axes Bending-torsional Coupled Vibration of Euler Bernoulli Beams under Axial Load
轴向受载的Euler-Bernoulli梁的双向弯曲扭转耦合振动研究
11.
As the crankshaft rotates, the crankpin swings in a circle around the shaft.
随着曲轴的转动，曲柄销绕主轴作圆周摆动。
12.
moving or directed toward the center or axis, especially when spinning or traveling in a curve.
向中心或轴线移动或者朝向中心或轴线，特别是在以曲线旋转或者移动的时候。
13.
Research on Bending Rotation Test of Rotation Shaft in Point the Bit Rotary Steerable System
指向式旋转导向系统旋转轴弯曲旋转试验研究
14.
Steering Knuckle Separation From Driveshaft
转向关节与驱动轴分离
15.
crossed parallelogram
平行四边形电流换向器方向转动的曲柄
16.
a shaft with screw thread (the worm) meshes with a toothed wheel (the worm wheel); changes the direction of the axis of rotary motion.
螺纹杆与齿轮相啮合；改变轴旋转运动的方向。
17.
coupling that connects two rotating shafts allowing freedom of movement in all directions.
连接两个转轴可以在任何方向自由移动的耦合。
18.
The blades at its periphery throw off air centrifugally in a direction following the rotation.
轮周叶片将空气沿着转动方向抛离轴心。