1.
Calculation and Design for caster angle of Cardan Shaft in Skew Rolling Mill
斜轧机的万向联结轴倾角的计算与设计
2.
Failure Analysis and Structure Improvement for the Cardan Joint
十字轴万向联轴器的失效分析和结构改进
3.
Driving system consists of gearwheel box, universal couplings and arc-gear synchronous belt.
传动系统采用齿轮箱、万向轴联轴器、圆弧齿同步带相结合。
4.
clutch and shaft coupling (including universal joints)
离合器及联轴节（包括万向节）
5.
Research on the Design of Coupler Used in Rolling Mill;
轧钢机用万向联轴器的设计分析研究
6.
The Research on Equal-strength Design of Large-scale Heavy-load Cross-shaft Universal Clutch
大型重载十字轴式万向联轴器等强度设计研究
7.
Driving system consists of gearwheel box, universal shaft coupling and arc-gear synchronous belt, The driving mechanical parts are installed at the bottom, so it can avoid vibration.
传动系统采用齿轮箱、万向轴联轴器、圆弧齿同步带相结合型式，传动构件安装在底板，避震性好。
8.
Driving system consists of gearwheel device, universal joint couplings and synchronous belt with high driving accuracy and low mechanical consumption.
传动系统采用齿轮箱、万向轴联轴器，同步带相结合型式，传动精度高，机械损耗小。
9.
ANALYSIS ON FRACTURE OF UNIVERSAL JOINT CROSSSHAFT OF MELT PUMP AND THE COUNTERMEASURES
造粒机组万向联轴器十字轴轴颈断裂分析及对策
10.
Synchronizing universal coupling with ball and socket
GB/T7550-1987球笼式同步万向联轴器试验方法
11.
Theory Research of the Constant Velocity Universal Joint and Its Computer Simulation;
等角速万向联轴器的理论研究及计算机仿真
12.
The dynamic virtual analysis of the tripod sliding universal joint
三叉杆滑块式万向联轴器动力虚拟分析
13.
Study on Design Method of Cardan Cross-pin Spindles Based on COM/COM+;
基于COM/COM+组件技术的十字轴式万向联轴器设计方法的研究
14.
Fuzzy Optimum Design of the Intermediate Shaft of Double Universal Coupling Shaft Based on MATLAB
基于MATLAB软件的双万向联轴节中间轴的模糊优化设计
15.
Structural Strength Analysis of Constant Velocity Joints for Car Drive-shaft by Finite Element Method;
轿车驱动轴等速万向节结构强度的有限元分析
16.
two -joint inboard slip drive shaft
两万向节滑动的传动轴
17.
flange crossing-transmission shaft universal joint
凸缘叉-传动轴万向节
18.
" Synchronizing universal coupling with ball and socket--Type, foundational parameters and main dimensions"
GB/T7549-1987球笼式同步万向联轴器型式、基本参数和主要尺寸