1.
reverse anchor jam nut
反向锁闭机构紧固螺帽
2.
BRACKET MOUNTING NUTS
支架固定螺帽（2）
3.
Install differential case and dummy bearings in axle housing (without shims) and tighten retaining cap bolts.
在轴壳内（没有垫片）安装差速箱和模型轴承，并紧固固定帽螺栓。
4.
lock nut of iron or stee
锁紧螺帽,防松螺帽,铁或钢制
5.
Loosen the compression nut tool.
放松压紧螺帽工具。
6.
except the screws and nuts that held the knocker.
只有固定门环的螺丝和螺帽。
7.
These nuts and bolts hold the wheels on.
这些螺帽和螺栓把轮子固定住了.
8.
Remove hinge retaining nuts from studs.
从双头螺栓拆下固定铰链的螺帽。
9.
These bolts and nuts hold the wheels on.
这些螺栓和螺帽把轮子固定下为。
10.
EVAP Canister Mounting Nuts (canister-to-mounting bracket)
EVAP罐固定螺帽（罐到固定支架）
11.
" Tolerances for fasteners--Bolts, screws and nuts"
GB/T3103.1-1982紧固件公差螺栓、螺钉和螺母
12.
General rules of tightening for threaded fasteners
GB/T16823.2-1997螺纹紧固件紧固通则
13.
Tighten glass track nuts to 6 N·m (in-lbs) torque.
拧紧玻璃轨道螺帽至6 N·m (in-lbs)扭力。
14.
Torquing Tie Rod End Attaching Nut
拧紧转向拉杆端接合螺帽
15.
Install the bushing by tightening the Long Nut.
通过扭紧长螺帽来安装衬套。
16.
Tighten wheel nuts until all are properly torqued, to eliminate brake distortion.
拧紧车轮螺帽直到所有螺帽都达到适当的扭力，以免刹车变形。
17.
"Bolts,screws & nuts"
"螺栓,螺丝及螺帽"
18.
A tool for clinching nails, screws, or bolts.
紧钳固定钉子、螺丝或螺丝钉的工具