1.
Lock rings at the end of shaft with bolt
GB/T892-1986螺栓紧固轴端挡圈
2.
Study on Localization Technology of Bolt Fasteners for CPR1000 Internals
CPR1000堆内构件螺栓紧固件的转化设计
3.
" Tolerances for fasteners--Bolts, screws and nuts"
GB/T3103.1-1982紧固件公差螺栓、螺钉和螺母
4.
Fasteners--Clearance holes for bolts and screws
GB/T5277-1985紧固件螺栓和螺钉通孔
5.
" Mechanical properties of fasteners--Bolts, screws and studs"
GB/T3098.1-1982紧固件机械性能螺栓、螺钉和螺柱
6.
Replace the body bolts and tighten evenly.
重新放置阀体螺栓,并均匀紧固。
7.
Tighten exhaust manifold to cylinder head bolts.
紧固排气岐管汽缸头螺栓。
8.
Experimental Study on Fastening Bolt Axial Force of WSGG Anchor Basted on CFRP Sheet
CFRP波形齿锚具紧固螺栓轴力的试验
9.
Fasteners--Counterbores for hexagon bolts and nuts
GB/T152.4-1988紧固件六角头螺栓和六角螺母用沉孔
10.
" Fasteners--General requirements for blots,screws,studs and nuts"
GB/T16938-1997紧固件螺栓、螺钉、螺柱和螺母通用技术条件
11.
" Fasteners--Bolts,screws,studs and nuts--Symbols and designations of dimensions"
GB/T5276-1985紧固件螺栓、螺钉、螺柱及螺母尺寸代号和标注
12.
" Mechanical properties of fasteners--Stainless steel bolts,screws, studs and nuts"
"GB/T3098.6-1986紧固件机械性能不锈钢螺栓,螺钉,螺柱和螺母"
13.
" Mechanical properties of fasteners--Bolts, screws, studs and nuts made of non-ferrous metals"
GB/T3098.10-1993紧固件机械性能有色金属制造的螺栓、螺钉、螺柱和螺母
14.
" Surface discontinuities of fasteners on bolts, screws and studs for general requirements"
GB/T5779.1-1986紧固件表面缺陷--螺栓、螺钉和螺柱--一般要求
15.
Surface discontinuities of fasteners on bolts screws and studs-Special requirements
GB/T5779.3-1986紧固件表面缺陷--螺栓、螺钉和螺柱--特殊要求
16.
" Tolerances for fasteners--Bolts, screws and nuts for fine mechanics"
GB/T3103.2-1982紧固件公差用于精密机械的螺栓、螺钉和螺母
17.
Tighten all bolts evenly as for a standard flange assembly.
均匀地紧固所有螺栓,形成标准的法兰总成。
18.
After seven days, the grouted mortar will have concreted, then we shall tighten the anchor bolts.
灌浆在七天以后凝固,我们就将拧紧地脚螺栓。