1.
Fuzzy Optimum Design of the Intermediate Shaft of Double Universal Coupling Shaft Based on MATLAB
基于MATLAB软件的双万向联轴节中间轴的模糊优化设计
2.
clutch and shaft coupling (including universal joints)
离合器及联轴节（包括万向节）
3.
OPTIMAL CONTROL FOR THE ATTITUDE MOTION OF COUPLED RIGID BODIES SPACECRAFT WITH UNIVERSAL-JOINT MODEL
带有万向联轴节双刚体航天器姿态运动的最优控制
4.
two -joint inboard slip drive shaft
两万向节滑动的传动轴
5.
flange crossing-transmission shaft universal joint
凸缘叉-传动轴万向节
6.
"The driving shaft causes the spider to rotate, and the other two trunnions of the spider cause the driven shaft to rotate."
主动轴使万向节十字轴转动,另外两个万向节十字头使从动轴转动。
7.
"When the two shafts are at an angle to each other, the bearings in the yokes permit the yokes to swing around on the trunnions with each revolution."
当两轴相互处在同一角度上,主动轴转动时万向节叉上的轴承使万向节叉绕万向节十字轴摆动。
8.
"The four arms of the spider, known as trunnions, are assembled into bearings in the ends of the two shaft yokes."
万向节十字轴的四个轴颈叫做万向节十字头,分别装在两个万向节叉顶端的轴承中。
9.
plunging constant velocity joint
可轴向移动的球笼式万向节
10.
two joint onboard slip drive shaft
两万向节外侧滑动传动轴
11.
Separate the rear universal joint from the transfer case yoke.
从传动箱轴轭上拆下后万向节。
12.
Finite element analysis of cross axle axis universal joint based on the Nastran
基于Nastran的十字轴万向节有限元分析
13.
Remove the universal joint strap bolts at the pinion shaft yoke.
在小齿轮轴轴轭处拆卸万向节扣夹螺栓。
14.
An analysis for partial damage cau-ses of cross shaft journal of auto-mobile universal joint
汽车万向节十字轴轴颈局部损坏原因分析
15.
Research on the Design of Coupler Used in Rolling Mill;
轧钢机用万向联轴器的设计分析研究
16.
Failure Analysis and Structure Improvement for the Cardan Joint
十字轴万向联轴器的失效分析和结构改进
17.
The Research on Equal-strength Design of Large-scale Heavy-load Cross-shaft Universal Clutch
大型重载十字轴式万向联轴器等强度设计研究
18.
ANALYSIS ON FRACTURE OF UNIVERSAL JOINT CROSSSHAFT OF MELT PUMP AND THE COUNTERMEASURES
造粒机组万向联轴器十字轴轴颈断裂分析及对策