1.
holes in joints of welded vessels
焊接容器接头处的孔
2.
openings through welded joints
通过焊接连接处的开孔
3.
Pull the switch out from the mounting hole in the door opening far enough to access the wire harness connector.
从车门洞里的固定孔中将开关拉出足够远，以便能处理线束接头。
4.
Make four indentations into the condenser near the standard cone joint.
在冷凝器接近标准圆锥接头处打四个穴孔。
5.
Discussion on Heat Treatment of 3Cr2W8V Three Rolls Punching Stamp
3Cr2W8V钢制三辊穿孔顶头的热处理探讨
6.
hydraulic gun release sub
射孔器水力丢手接头
7.
plug-and-jack type connector
插头-插孔式连接器
8.
automatic gun release sub
射孔器自动丢手接头
9.
RIGHT DOOR KEY CYLINDER SWITCH CONNECTOR
右门钥匙插孔开关接头
10.
Heat Treatment Strengthening of Al─Li Alloy 2091 Welded Joint
2091铝锂合金焊接接头的热处理强化
11.
Slag, blowholes, and paint on unfused regions were observed at the welded junctions.
在焊接处看到了夹渣，气孔及未熔透区的油漆。
12.
3-D Elastic and Plastic FEM Analysis of Hydraulically Expanded Tube-to-Tubesheet Joints with Tubesheet Hole Groove;
管板孔开槽的液压胀接接头三维弹塑性有限元分析
13.
Application of Improved Blind Hole Method to Welded Iron Tower Joint for Stress Relieving with Heat Aging
改进型盲孔法在铁塔焊接接头热时效消除应力中的应用
14.
Bring a comb, charged by combing hair, near to a tap in the dark.
把梳过头而带电的梳子靠近黑暗处的电线接头。
15.
USING AN OHMMETER MEASURE GROUND CKT AT BLUE CONN
用欧姆表测蓝色接头处的地电路
16.
Broken connector terminal or wire splice in fog lamp circuit.
雾灯电路的接头端子或电线熔接处断裂。
17.
Fatigue Performance Improvement of 22SiMn2TiB Steel Welded Joint by Ultrasonic Impact Treatment
超声冲击处理改善22SiMn2TiB钢焊接接头的疲劳性能
18.
Effect of Postweld Heat-treatment on Microstructure and Mechnical Properties of BHW35 Steel Welded Joint
焊后热处理对BHW35钢焊接接头组织性能的影响