1.
Safety Valve Design Theory for Bell and Spigot Joint for FW RPM Pipe
承插口玻璃钢夹砂管道安全阀设计理论
2.
ON-LINE SETTING OF SAFETY VALVE INSTALLED ON PIPELINE OF BOILERS FOR ULTRA-SUPERCRITICAL UNITS
超超临界机组锅炉管道安全阀在线整定
3.
On-line setting of safety valve in main steam pipe of ultra-supercritical boiler
超超临界锅炉主蒸汽管道安全阀在线整定
4.
Detach the sensing line from the inlet ball valve and the elbow on the relief valve.
从进口球阀和安全阀上的弯头处拆卸感应管道。
5.
Install a 125 PSI pressure relief valve in the cold water supply line.
在冷水供应管道上安装一个125PSI的减压安全阀。
6.
"The discharge line must be the same size as the valve outlet, and must pitch downward from the valve to a safe place for disposal."
排泄管道必须与安全阀出口具有相同的口径,必须从安全阀的下方接到安全排放地点。
7.
Relief valve must be piped to a suitable drain.
安全阀必须配置通向适当排泄口的排泄管道。
8.
Activate the T &P Valve to release any water in the piping.
打开降温减压安全阀释放管道内的任何水。
9.
Calculation and Discussion on the Vent Pipe Strength of Boiler Safety Valve in 330MW Unit
330MW机组锅炉安全阀排汽管道强度核算及探讨
10.
The discharge line must be installed to allow complete drainage of both the relief valve and the discharge line.
排泄管道必须能够完全容纳安全阀和排泄管的排泄物。
11.
a safety, exhaust valve
安全阀、 排气阀.
12.
The relief valve should never be solidly piped into a drainage ditch, sewer or sump.
安全阀绝不能用坚硬的管道连接到排水沟、水管或污水坑里。
13.
safety valve dome
安全阀汽包，安全阀座
14.
Assessing the safety of fully welded body pipeline ball valve
全焊接阀体管线球阀焊接接头的安全评估
15.
Vent the air gap and drain line from the relief valve in accordance with code requirements.
按照规程的要求，排出安全阀气隙和排放管道的空气。
16.
A water heater's temperature and pressure relief valve must be piped to the nearest drain in order to avoid damage in the event the valve is actuated.
热水器的降温减压安全阀必须用管道连接到最近的排水口，以避免万一阀门启动所造成的破坏。
17.
Remove the relief valve hose from fitting below inlet ball valve.
从进口球阀下面连接件拆卸安全阀软管。
18.
Grooved butterfly valves direct connect to pipe using iron pipe size couplings. Grooved valves are easiest to install.
管状蝶阀:采用铸铁管接头直接与管道连接。管状阀门安装最容易。