1.
After loosening bolts with a 9/16" socket, remove bolts completly.
在用9/16英寸套筒松开螺栓后，将螺栓完全拆卸下来。
2.
Loosen but do not fully remove the four bolts that attach the stabilizer bar bushing retainers to the rear axle brackets.
松开但不完全拆卸接合稳定杆衬套扣环与后车轴支架的4支螺栓。
3.
CLEN fliters are generally fully disassembled, except for the body-motor-motor bracket-fan unit, for delivery to customers.
除机身、机、机托架和风扇是一体的部件外，CLEN过滤器发给客户的时候是完全拆卸开的?
4.
Remove the plastic thermostat cover from the thermostat( s) making sure to disengage the attachment point from the thermostat.
从温控器上拆卸塑料温控器盖，确保与温控器上固定点完全分离。
5.
Remove the cover plate of the relief valve by removing the four connecting screws.
通过拆卸四个连接螺丝来拆卸安全阀盖板。
6.
Remove the plug gauge and complete the inverted flare.
拆卸塞规并完成反转扩口。
7.
Stripped Bonds and Stripped Coupons
拆卸债券及拆卸息票
8.
Reassemble the relief valve in the reverse order that it was disassembled.
按照拆卸的相反顺序重新组装安全阀。
9.
DISCONNECT THE SEAT BELT CONTROL MODULE.
拆卸座位安全带控制模组。＊＊
10.
Remove the relief valve cover bolts while holding the cover down.
边压住阀盖，边拆卸安全阀阀盖螺栓。
11.
completely knocked down
完全击倒完全低价完全拆开
12.
The whole equipment can be assembled and dismantled in a matter of hours.
整套设备可以在几小时内安装或拆卸完毕。
13.
The relief valve should be able to be removed by unscrewing the relief valve from the housing.
通过从外壳上旋下安全阀应该能够拆卸安全阀。
14.
Remove the relief valve cover, stem/diaphragm assembly, and relief valve spring.
拆卸安全阀阀盖，阀杆/隔膜总成，和安全阀弹簧。
15.
Remove the pressed in relief valve seat and seat O-ring.
拆卸压进去的安全阀阀座和阀座O形环。
16.
Remove the relief valve hose from fitting below inlet ball valve.
从进口球阀下面连接件拆卸安全阀软管。
17.
Detach the sensing line from the inlet ball valve and the elbow on the relief valve.
从进口球阀和安全阀上的弯头处拆卸感应管道。
18.
One error might make it necessary to pull the whole thing apart and start over again.
只要出一点差错，就可能要全部拆卸，重新装配。