1.
The gasket face of the flange should squarely contact the face of the mating flange.
法兰垫圈面应该与配套法兰面均匀接触。
2.
Washers with ball face
GB/T849-1988球面垫圈
3.
Washers with cone face
GB/T850-1988锥面垫圈
4.
Inner sphere washers
GB/T1030-1988内球面垫圈
5.
horse shoe washer
开口垫圈,马蹄形垫圈
6.
Seat Face: Negates need for flange gaskets.
阀座表面:不需要使用阀兰垫圈。
7.
Spacer ring provides bearing surface and prevents deformation of the gasket.
隔离环提供支撑面，防止垫圈的变形。
8.
Chamfered washer or spacer with adjustable inside and outside diameters and chamfer.
内径和外径以及斜面都可调整的切角垫圈或垫片。
9.
Washers with split
GB/T851-1988开口垫圈
10.
Plain washers--Small series--Product grade A
GB/T848-1985小垫圈--a级
11.
Plain washers--Normal series--Product grade A
GB/T97.1-1985平垫圈-a级
12.
Specifications for spring washers--Single coil spring lock washers
GB/T94.1-1987弹性垫圈技术条件弹簧垫圈
13.
Sufficient force is required to push the metal sealing surfaces into the washer; too much force will damage the bead surfaces.
要求足够的力量来把金属密封表面推进垫圈，但太大的力量会损伤垫珠表面。
14.
A wide range of standard stampings, non-standard products, stainless steel washers, internal/ external teeth washers, rings, circlips for holes, circlips for shaft, other fasteners, fittings, seal washers and clamps主要生产各种标准件冲压件.各种非标产品.
不绣钢垫圈;内外齿垫圈;挡圈;孔用挡圈;轴用挡圈;纱嘴头,其他紧固件、接件密封垫圈卡圈.
15.
Secure the controller to the floor/base plate with bolts and washers and tighten.
用螺栓和垫圈,将控制装置安全地紧固在地面/底板上。
16.
Standard finish of gasket surface is125-200 micro-inch maximum roughness.
垫圈表面的标准光洁度最大为125-200百万分之一英寸粗糙度。
17.
Plain washers--Large series--Product grades A and C
GB/T96-1985大垫圈-A和c级
18.
Plain washers--Product grade C
GB/T95-1985平垫圈-c级