说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 阀调整
1.
To regulate the speed of(an engine)with a throttle.
节流用节流阀调整(发动机)的速度
2.
A valve that regulates the flow of a fluid, such as the valve in an internal - combustion engine that controls the amount of vaporized fuel entering the cylinders.
节流阀调整流体流动的阀门,如内燃机中控制蒸汽燃料进入汽缸的量的阀门
3.
Stand clear of the regulator and valve outlet, while opening the valve.
开启阀门时,躲开调整器和阀门排气口。
4.
Diaphragm valves cannot be repaired or adjusted in the field.
不能在现场修理或调整隔膜阀。
5.
internally piloted regulator
整体指挥器操作型自力式调节阀
6.
Valve without actuator. Two-way or 3-way can be specified. Valve ports can be resized.
没有传动装置的阀门。可以指定双向或三向。可调整阀口的大小。
7.
Close the regulator. To close the regulator, turn the adjusting knob to the full counter-clockwise position. The regulator must be closed before opening the cylinder valve.
关闭调整器。要关闭调整器,把调整钮逆时针旋死。在开启钢瓶阀门之前,必须关闭调整器。
8.
Always pressurize a regulator slowly, while standing with the cylinder valve between you and the regulator.
总是站得使钢瓶阀门位于你和调整器之间,对调整器慢慢加压。
9.
So I throttled back to just above stalling Speed.
于是我调整节流阀,只比失速时稍微快一点。
10.
Charging test and safety valve and automatic device adjusting for main compressor( auxiliary compressor).
主()气压缩机的充气试验、全阀和自动装置的调整。
11.
Provides adjustable alignment, eliminates body wall penetrations.
具有可调整定位功能,避免阀体壳壁被穿透。
12.
Study on Adjust Shim Thickness and Affection to Throttle Opening Velocity of Hydro-pneumatic Spring
油气弹簧调整垫片厚度及对开阀速度影响
13.
Research of Intelligent Digital Flow Valve Based on Fuzzy Self-adaptive PID Control
基于模糊自调整PID控制的智能数字流量阀研究
14.
pressure controlled valve
压力调节阀压力控制阀
15.
With the regulator adjusting knob turned fully counterclockwise, place both hands on the cylinder valve and open it slowly, allowing the pressure to rise gradually in the regulator.
调整器的调节钮逆时针旋死后,两只手放在钢瓶阀门上,慢慢地开启,使调整器内的压力逐渐增加。
16.
Use a pressure reducing regulator or separate control valve to safely discharge gas from cylinders. Use a check valve to prevent reverse flow into the cylinder.
使用减压调整器或单个的控制阀来安全地从钢瓶中排出气体。采用止回阀,防止回流入钢瓶。
17.
The circular male and female bonnet joint is self-aligning and encapsulates the gasket.
圆形外螺纹和内螺纹阀盖连接是自行对准调整并且封装的垫圈。
18.
Use a pressure-reducing regulator or separate control valve to safely discharge gas from a cylinder.
使用减压调整器或单独的控制阀门来从钢瓶内安全的排出气体。