1.
Position sensor to throttle body while guiding rubber fitting over throttle body vacuum nipple.
在节气阀体真空管接头上面操纵橡胶管件时，定位感知器至节气阀体。
2.
Connect all the vacuum hoses and wire connectors identified during engine removal.
连接所有在拆卸引擎中确定的真空软管和电线接头。
3.
a six-valve set
六真空管电报接收机
4.
Connect vacuum line to EGR valve.
将真空管路连接到EGR阀。
5.
The vacuum system consists of vacuum pumps, vacuum pipelines, vacuum valves and vacuum measurers.
真空泵、空管道、空阀门和真空测量头组成了真空系统。
6.
The Experimental Study on Vacuum Performance of Non-magnetic Dewar Adhesive Joints
无磁杜瓦粘接接头真空性能的实验研究
7.
Microstructure and Properties of Vacuum Diffusion Bonded CLAM Steel Joint
真空扩散连接CLAM钢接头的微观组织与性能
8.
Models8 A,8 B,8 FR and8 P hose connection vacuum breakers are constructed to allow sill cocks to be drained.
型号8A,8b,8FR和8P软管连接真空断路阀其b>结构b>允许洒水龙头排放。
9.
Flared type tube fittings--Inverted flare bolts
GB/T5650-1985扩口式管接头空心螺栓
10.
Connect all previously removed vacuum hoses.
连接所有以前拆去的真空软管。
11.
Connect vacuum hose to booster check valve.
连接真空软管到增压器检测阀。
12.
Research on Preparation and Properties of Cu/Ti_3SiC_2 Vacuum Contact Material
Cu/Ti_3SiC_2真空触头材料的制备与电接触性能研究
13.
Experimental Research on Vacuum Diffusion Bonding of PDC Bit
PDC钻头真空扩散焊接工艺正交试验研究
14.
Disconnect the vacuum harness connector from the back of the heater-A/C mode control switch on the control panel.
从控制仪表板上的空调暖气模式控制开关上断开真空线束接头。
15.
Microstructure and Properties of Vacuum Brazing C_f/C Composites Using Reactive Al Based Filler Metals
铝基活性钎料真空钎焊C_f/C复合材料焊接接头的组织及性能
16.
Performance Research on Vacuum Destressing Annealing of TC4 Electron Beam Welded Joint
TC4钛合金电子束焊接接头的真空去应力退火工艺研究
17.
The Deformation of Welded 6063 Aluminium Alloy T-joints in Thin-walled Rectangular Hollow Section as Well as FEM Simulation;
6063铝合金薄壁管T型接头变形及有限元仿真
18.
The channels and the junctions have a more or less uniform spatial distribution.
管子和接头具有大体上均匀的空间分布。