1.
Upper Main Bearing Removal and Installation with Tool C-3059
用工具C-3059进行上主轴承拆卸与安装
2.
upper center crankshaft bearing
曲轴主轴承上中轴瓦
3.
Remove thrust bearings from rear main bearing carrier.
从后主轴承托架上拆下止推轴承。
4.
Application of Oil Gas Lubrication Technique to Bearing of High-Speed Motorized Spindle
油气润滑技术在高速电主轴轴承上的应用
5.
The feed holes for the crankshaft main bearings.
曲轴主轴承进入口。
6.
Crankshaft and main bearings service
曲轴和主轴承的维修
7.
Install the lower bearing inserts into the main bearing caps.
安装下轴瓦到主轴承盖。
8.
This bearing limit rotational speed is low, (therefore mainly applies on the mill calls rolling mill bearing).
该轴承极限转速较低，主要应用于轧钢机上（故称轧机轴承）。
9.
Remove the lower insert from the bearing cap.
从轴承盖上拆去下轴瓦。
10.
The journal rubs against the bearing surface.
轴颈在轴承面上摩擦。
11.
The Model Analysis of the Ceramic Bearing Electric Spindle;
陶瓷轴承电主轴主轴的振动模态分析
12.
These are the same as those used for the main bearings.
这些轴承与那些被用作主要轴承的轴承相同。
13.
"When the two shafts are at an angle to each other, the bearings in the yokes permit the yokes to swing around on the trunnions with each revolution."
当两轴相互处在同一角度上,主动轴转动时万向节叉上的轴承使万向节叉绕万向节十字轴摆动。
14.
Modeling for Rotor System of AC Magnetic Bearing Electric Spindle;
交流磁轴承支承电主轴转子系统建模
15.
Undersize crankshaft main bearing journals.
尺寸小于标准的凸轮轴主轴承轴颈。
16.
main drive gear bearing oil slinger
主动齿轮轴承抛油环
17.
drive pinion cone bearing
主动小齿轮锥形轴承
18.
differential drive pinion cage bearing
差速器主小齿轮轴承罩