1.
The switch wire harness must be disconnected before testing switch continuity.
在测试导通性之前必须断开开关线束。
2.
Position switch into license plate lamp housing and connect switch harness connector.
定位开关到牌照灯壳，连接开关线束接头。
3.
Unplug the wire harness connector from the switch.
从开关拔出线束接头。
4.
Unplug the wire harness connectors from the multi-function switch.
从多功能开关上拔出线束接头。
5.
Pull the power mirror switch away from the trim panel far enough to access the wire harness connector.
从装饰板拉电动视镜开关足够远，找到线束接头。
6.
All-Optical Switching in Polymer Pumped by a Beam with Linear-Circular Double Polarization
线-圆双偏振态光束抽运有机聚合物全光开关
7.
Disconnect the harness (on the sensor) from the main electrical harness.
从主电线束断开该线束(在感知器上)
8.
Disconnect the vacuum harness connector from the back of the heater-A/C mode control switch on the control panel.
从控制仪表板上的空调暖气模式控制开关上断开真空线束接头。
9.
Ignition cable; Control cable sets; Switch cabinet; Electrical& hand coupler for vehicles.
汽车点火线束；大中型机械控制线束；开关控制箱；有轨机车电气/动联接器。
10.
Ignition cable; Control cable sets; Switch cabinet; Electrical &hand coupler for vehicles.
汽车点火线束；大中型机械控制线束；开关控制箱；有轨机车电气/手动联接器。
11.
Disconnect wiring to cargo lamp.
断开至载货灯的线束。
12.
Pull the switch out from the mounting hole in the door opening far enough to access the wire harness connector.
从车门洞里的固定孔中将开关拉出足够远，以便能处理线束接头。
13.
Unplug the wire harness connector from the low pressure cycling clutch switch on the top of the accumulator.
从蓄压器顶部的低压循环离合器开关上拔下线束接头。
14.
Drag to change end date of the expanded timeline.
拖动可更改展开的时间线的结束日期。
15.
Disconnect retractor wire harness connector.
断开皮带卷收器线束接头。
16.
If equipped, disconnect mirror harness wire connector.
如果配备，断开镜子线束接头。
17.
Disconnect the power windows wire harness connectors, if equippe
如果已配备，拆开电力车窗线束接头。
18.
Disconnect wire harnesses and washer hose from liftgate.
从升降闸门上断开线束和清洗器软管。