1.
Verify Crankshaft—Camshaft Installation—Typical
验证曲轴—凸轮轴安装—典型的
2.
cam shaft driving gear
凸轮轴传动齿轮凸轮轴传动装置
3.
cam shaft drive
凸轮轴传动凸轮轴传动装置
4.
Install the timing chain, crankshaft sprocket and camshaft sprocket with the timing marks aligne
安装正时链、曲轴链轮和凸轮轴链轮，使正时标记对齐。
5.
Install a new cam bolt, cam and new nut in the axlRe-align the reference marks.
在轴上安装新凸轮螺栓，凸轮和 新螺帽。重新校准参考标记。
6.
The camshaft also fits inside the block, except on overhead-cam engines( OHC).
除了顶置凸轮(HC)动机以外，凸轮轴都安装在气缸体里面。
7.
cam shaft reversing lock
凸轮轴换向闭锁装置
8.
Two TDC (Top Dead Center) sensors are mounted at the rear of the single camshaft.
两个上死点的传感器安装在凸轮轴的后面。
9.
It is not advisable to attempt to replace camshaft bearings unless special removal and installation tools are available.
不要试图更换凸轮轴轴承，除非能够使用特殊的拆卸和安装工具。
10.
overhead cam shaft
上凸轮轴上部凸轮轴
11.
As the camshaft continues to rotate, the high spot moves way from the valve mechanism.
因为凸轮轴继续旋转，凸轮轴上的凸起部分离开气门装置。
12.
Design and Dynamic Simulation of Cam Automatic Feeding System for Assembled Camshaft
装配式凸轮轴凸轮上料系统设计及动力学仿真
13.
camshaft(journal )turning lathe
凸轮轴（轴颈）车床
14.
Sometimes the camshaft is fitted directly into the cylinder head and operates on the valves without rockers.
有时，凸轮轴直接安装在气缸盖上并且不用摇臂控制阀门工作。
15.
Install rotor on axle hub.
在车轴轮毂上安装转子。
16.
Design and Simulation of Assembled Camshaft's Mandrel Automatic Transportation System
装配式凸轮轴芯轴自动上料系统的设计及仿真
17.
the maximum movement available to a pivoted or reciprocating piece by a cam.
安装在枢轴上或作往复运动的部件，从凸轮、曲柄或偏心轮所得到或能得到的运动极限。
18.
Research on the Automatic Equipment for the Jointing of the Knurling Assembled Camshaft End Socket;
滚花装配式凸轮轴端头连接自动化装备研究