1.
Measuring diameter of fore and aft stern tube bearing and bushes.
艉轴管前、轴承与衬套直径测量。
2.
An adapter threaded to permit joining of pipes with different diameters.
导线套管允许不同直径的导线形成的导线束通过的衬套
3.
Pressure Calculation of Powder Gas in Bush Radial Clearance
衬套径向间隙部位火药气体压力计算
4.
Sintered metal bushes--Determination of radial crushing strength
GB/T6804-1986烧结金属衬套径向压溃强度测定法
5.
Align the bushing with the spring eye or shackle eye and tighten the nut at the socket wrench end of the threaded roTighten until the bushing is forced into the spring eye.
将衬套对准弹簧眼或U型钩眼，并在螺纹杆的套筒板手末端锁紧螺帽。锁紧直到衬套进入簧眼。
6.
Tighten leaf spring press until bushing is extracted from leaf spring.
上紧叶片弹簧加压机直到衬套被拔出叶片弹簧。
7.
Hold puller screw and tighten puller nut until bushing is remove
握紧拉拔器螺栓，拧紧拉拔器螺母，直至拆下衬套。
8.
Hardness Decreasing Reason of Airscrew Bush Parts of Helicopter after Heat Treatment
直升机旋翼桨根衬套热处理后硬度降低的原因
9.
Summarize technique exchange of compound tower lining with urea Φ1400mm
直径1400毫米尿素合成塔衬里更换工艺概述
10.
fitting rubber liner for stern tube
尾轴管橡胶衬套嵌套
11.
Bushings: Furnishes shaft support at three locations for positive shaft alignment and actuator support.
衬套:在三个位置上配置轴支撑,有利于轴校直和执行机构的支撑。
12.
Bushings (4): Furnishes shaft support at three locations for positive shaft alignment and actuator support.
衬套（4）：在三个位置上配置轴支撑，有利于轴校直和执行机构的支撑。
13.
The relationships among perforation diameter, density, phase and casing strength are clarified.
明确了射孔直径、度及相位等与套管强度的关系。
14.
This gold-plated copper commemorative medallion set includes 5 pieces, each with a diameter of 40mm.
此套纪念章共5枚，材质为铜质镀金，直径40毫米。
15.
This gold-plated copper commemorative medallion set includes 5 pieces, each of a diameter of 40mm.
此套纪念章为铜质镀金，直径40毫米，共5枚。
16.
Numerical Iteration Method for Modifying Measurement Error of Diameters of Steel Ball or Ring
套圈和钢球直径测量误差修正的数值迭代法
17.
Construction Technology of Bushing Complete and Larger Diameter Drilling Machine for Land-collapsing with High Frequency Vibration
全套管大直径高频振动取土灌注桩施工技术
18.
Design and manufacture of hight pressure seal thread socket with large ddameter and big pitch
大直径大螺距高压密封螺纹套管设计与制造