1.
The Study and Application about Virtual Instruments Technology in TEE Function Measurement;
虚拟仪器技术在油泵支架总成功能测试中的研究与应用
2.
Topology Optimization of a Power Train Mount Bracket With Multi Load Cases Constrains
动力总成悬置支架的多工况拓扑优化
3.
The Optimization Design for the Powertrain Mounting Bracket of Car JOYEAR
景逸汽车动力总成悬置支架的优化设计
4.
Main products: oil tank, oil tube, oiler support, oil pump, oil applying wheel etc.
产品主要结构：油箱、油管、安装支架、油泵总成及涂油轮等组成。
5.
The power-train mount bracket has been researched by topological optimization method.
采用结构拓扑优化方法，对动力总成悬置支架进行了优化。
6.
A Study on Topology Optimization of Powertrain Mount Bracket Based on Finite Element Technique
基于有限元技术的动力总成悬置支架拓扑优化的研究
7.
Lower engine with lifting fixture while aligning engine support insulator assembly into sill bracket assembly.
用提升装置降下引擎，同时将引擎支座绝缘体总成对正，放入横梁托架总成内。
8.
Design of the Hydraulic Power Support Control System Based on CAN Bus;
基于CAN总线液压支架控制系统的设计
9.
Install thrust support assembly.
安装侧推支撑总成。
10.
An Optimization Framework for Missile General Design with Multi-method Collaboration Support;
支持多方法协作的导弹总体设计优化框架研究
11.
Design of Electro-hydraulic Control System Based on Double CAN-Bus Used in Power Support
基于双CAN总线的液压支架电液控制系统设计
12.
Design of the Hydraulic Power Support Monitoring and Control System Based on Double CAN Bus
基于双CAN总线液压支架监控系统的设计
13.
Design of Hydraulic Support Control System Based on Double CAN Buses
基于双CAN总线的液压支架控制系统的设计
14.
Shield Type Hydraulic Support Overall Parameter Optimizes Mathematical Model
掩护式液压支架总体参数优化的数学模型
15.
The logistics simulation study on the car rear seat backrest frame assembly;
轿车后座靠背骨架总成物流仿真研究
16.
The Development of Real Axle Fatigue Lift Testing
驱动桥总成疲劳寿命试验台架的研制
17.
Experimental Study of Placing Degradable Stent in Common Bile Duct and Laser Welding of It after Common Bile Duct Exploration;
胆总管探查术后内置可降解支架并行激光焊接胆总管的实验研究
18.
a supporting structure composed of a system of connected trestles; for a bridge or pier or scaffold e.g..
横木两端支以人字支脚而成，成对使用；以支撑桥梁、码头和绞手架等。