1.
Note: it is important the differential reading drop slowly.
注意：重要的是压差读数慢慢下降。
2.
After initial pressure differential reading is taken, refer to flow rate charts to obtain flow rate based on pressure differential and valve setting.
在获得初始压差读数后，参阅根据压差和阀门设置而得的流量表。
3.
If the differential reading does not decrease record check as tight.
如果压差读数没有降低，则记录止回阀为密封紧密。
4.
Record this as the opening differential pressure of the relief valve.
将此读数记录为安全阀开启压差。
5.
"The reading on the gauge, called the gauge pressure, is always the difference Between two pressures."
标尺上的读数,称为计示压力,通常是两个压力数之差。
6.
Usually the rake body makes the static readings high, and by shortening the tipstatic-orifice distance the error can be eliminated.
一般排管架使静压读数偏高，缩小管端静压孔的距离可以消除这个误差。
7.
At this point the gauge pressure was read.
立即记录油压表读数。
8.
The barometer began to fall.
气压计的读数开始下降.
9.
The vapor pressure above the mercury column and the specific weight of the mercury change.
为什麽气压计的压力读数，与温度有关?
10.
The Digital Capacitor Instrument Used for Measuring the Pressure (the Differential Pressure);
数字化电容式压力（差压）测量仪表
11.
Thermocouples age with time and readings drift.
热电偶随时间而老化，读数会偏差。
12.
Find the number on the pressure difference line and note the outlet pressure index number.
找出压差线上的数字，并且注意出口压力指数。
13.
Adjust balancing valve until pressure differential gauge reads pressure drop required for desired flow rate gpm.
调整平衡阀直到压差表读出压降符合所要求的流量（加仑/分钟）为止。
14.
Between sampling instants there is no registration of the voltage.
在取样瞬间之间，没有电压的读数。
15.
A voltmeter connected across A to B would read 10 volts.
两点间的电压表的读数应为10伏。
16.
Static pressure is the designed pressure difference within the pipeline between two testing points. It is a necessary date when selecting different types of pressure gauges.
静压是差压表两个检测点所在管道内的设计压力。它是差压压力表选型时必需的数据。
17.
Research on Digital Differential Protection for Power Transformer;
数字式变压器差动保护若干问题研究
18.
EXPERIMENTAL STUDY OF AFFECTING PARAMETERS IN PRESSURE PRE-COOLING OF FRUITS AND VEGETABLE
果蔬差压通风预冷影响参数试验研究