1.
Installing bolts allowed to use gas cutting bore hole and never more than two gaskets pad not sexual bolts, exposed screw bolt length of not less than2-3 deduction.
安装螺栓孔不允许用气割扩孔,永乆性螺栓不得垫两个以上垫圈,螺栓外露丝扣长度不少于2～扣.
2.
Install connecting rod bolt protectors on rod bolts.
在连杆螺栓上安装连杆螺栓保护件。
3.
LOWER TRACK BAR BOLT INSTALLATION
下横拉杆螺栓的安装
4.
Lower Ball Stud Remove/Install
上圆顶螺栓拆卸/安装
5.
The method is also proposed on making thread-hole and bolt in interving concerted process, bolt connection as well.
干涉配合螺接过程中螺孔和螺栓的加工方法以及螺栓的安装方法。
6.
Install the seat/shoulder belt anchor bolt.
安装座椅/安全肩带系紧螺栓。
7.
Correctly Installed Eccentric Attaching Bolt
安装正确之偏心接合螺栓
8.
Install the bolts attaching the end cap to the front fender.
安装连接末端端盖到前挡泥板的螺栓。
9.
Reinstall handwheel and secure with retaining bolt.
重新安装手轮，用固定螺栓加固。
10.
Install exhaust heat shield, tighten bolts to 11 N·m.
安装排气隔热罩，拧紧螺栓到11 N·m。
11.
The wall panels were bolted to the concrete foundation.
墙壁镶板用螺栓安装在混凝土地基上。
12.
Construction Supervision over Erection of High-Strength Friction Grip Bolts in Lightgauge Steel Structure
轻钢结构高强度螺栓安装的施工监理
13.
"Upon proper alignment of mounting holes, the two bolts and washers should be installed."
安装孔对准后,应该把两个螺栓和垫圈安装上去。
14.
a safety harness, bolt
安全带、 保险螺栓.
15.
Position flywheel and O-ring on crankshaft and align bolt holes.
安装飞轮和O形环在曲轴上并对齐螺栓孔。
16.
Position plate bracket and install attaching bolts through vehicle rear crossmember.
定位板托架并穿过车辆后横梁安装附接螺栓。
17.
Install the straps and bolts to hold the propeller shaft to the yoke.
安装扣夹和螺栓，将传动轴固定到轴轭上。
18.
Position lever assembly on floorpan and install lever mounting bolts.
将拉杆组合放置到底板上并安装拉杆固定螺栓。