1.
Upper Main Bearing Removal and Installation with Tool C-3059
用工具C-3059进行上主轴承拆卸与安装
2.
Remove side bearings from differential case.
拆卸差速箱处的侧轴承。
3.
Remove differential case and dummy bearings from axle housing.
拆卸轴壳内的差速箱和平衡轴承。
4.
Remove differential side bearings from differential case.
从差速箱拆卸差速器侧轴承。
5.
If the axle shaft and hub bearing are being removed in order to service another component, the axle shaft and hub bearing can be removed as an assembly.
如果维修时需拆卸主动轴和轮毂轴承,主动轴和轮毂轴承可作为一个总成加以拆卸。
6.
Research on the Quick Non-damage Dismantling of Bearings by Making Use of Industrial Frequency Induction Heating;
工频感应加热快速无损拆卸轴承技术研究
7.
Replacing precision-insert main bearings without removing the crankshaft requires about 5 hours. Removing and replacing the crankshaft requires several additional hours.
不拆曲轴更换精密嵌入型主轴承,大约需要5小时,拆卸和更换轴承要额外增加几小时。
8.
It is not advisable to attempt to replace camshaft bearings unless special removal and installation tools are available.
不要试图更换凸轮轴轴承,除非能够使用特殊的拆卸和安装工具。
9.
Remove the depth shims from rear pinion bearing cup bore in axle housinRecord the thickness of the depth shims.
从轴管里的后小齿轮轴承盖孔拆卸限深垫片。记录限深垫片厚度。
10.
Remove differential case from axle housing.
从轴管上拆卸差速箱。
11.
"On many engines, the connection-rod and main bearings (crankshaft bearings) can be checked for wear with an oil-leak detector before the engine is torn down."
许多发动机在拆卸之前,可以用漏油检测装置检查连杆和主轴承(曲轴轴承)的磨损情况。
12.
Development and ANSYS simulation of induction heating detacher for bearing inner race
轴承内环感应加热拆卸器的研制及其有限元仿真
13.
Remove the crankshaft from the cylinder block (refer to Cylinder Block Disassemble).
从汽缸体上卸去曲轴(参看“汽缸体-拆卸”)。
14.
Remove the lower insert from the bearing cap.
从轴承盖上拆去下轴瓦。
15.
"When the crankshaft is removed, it is the usual procedure to clean out the oil passages in the crankshaft."
拆卸曲轴时,通常应该清洁曲轴油道。
16.
Remove thrust bearings from rear main bearing carrier.
从后主轴承托架上拆下止推轴承。
17.
Soleplate which is adjustable slightly is installed on the speed reducer and bearing seat. The soleplate is easy installed and lower noise.
减速机和前、后轴承座,均设有可上下、左右微调的底板,安装、拆卸调试方便,噪音小。
18.
Remove the inboard seatback pivot bolt.
拆卸内侧座椅背枢轴螺钉。