1.
spring seat bearing adjusting nut
弹簧座轴承调整螺母
2.
wheel hub bearing adjusting nut
车轮毂轴承调整螺母
3.
steering gear adjusting nut lock
转向齿轮调整螺母保险
4.
Improper adjustment of differential bearings.
差速器轴承调整错误。
5.
differential adjusting wrench
分速分速器轴承调整扳手;分速器轴承调整扳手
6.
Tie Rod End Adjusting Sleeve Nut
转向拉杆端调整轴筒螺栓
7.
Lubricate adjuster screw threads and pivot with spray lube.
使用喷雾润滑油润滑调整器螺丝螺纹和枢轴。
8.
adjustable self-aligning bearing
可调节的自动调整式轴承
9.
Refer to Drive Pinion Bearing Pre-Load Adjustment.
参阅驱动小齿轮轴承预荷调整。
10.
Before performing this procedure, the worm bearing preload adjustment must be performe
进行本程序之前，必须调节螺杆轴承的预应力。
11.
The adjustment of rotation angle error of power box twin export axles of twin screw extruder
双螺杆挤压机动力箱双输出轴转角误差调整
12.
Front Stub Axle To Hub Bearing Nut
前螺桩轴至轮毂轴承螺帽
13.
Gear Box with Eccentric Bearing Jacket and Adjustment of Eccentric Bearing Jacket;
采用轴承偏心套的齿轮箱和轴承偏心套的调整方法
14.
The research of nut adjustment on micro-car clutch fork
微型汽车离合器分离拨叉螺母调整的研究
15.
Attach the regulator. Fasten the regulator to the cylinder and tighten the inlet nut securely.
连接调整器。把调整器紧固在钢瓶上，安全地上紧入口螺母。
16.
Control of geometric accuracy and operation adjustment method of tower forging bearing ring
塔锻轴承套圈几何精度的控制及操作调整方法
17.
"Semifinished main bearings require finishing and fitting after installation, so that the crankshaft must be taken out."
半精加工的主轴承安装后需要修整和调配,这样曲轴就必须拆下。
18.
Plain bearings-Shaft diameters for unsplit bushes
GB/T10445-1989滑动轴承整体轴套的轴径