1.
"After retracting the rear auxiliary feet, extend them until they touch the surface on which the balance rests."
旋出后面的地辅助脚至重新接触安装平面。
2.
Empennage-Install Stabilizer and Vertical Fin.
尾翼－安装水平安定面、垂直安定面。
3.
stabilizer actuator
水平安定面致动装置
4.
NOTE - Consult the appropriate job plans to determine the controller mounting location. Tools and materials (wall mounting) required
注意:请参阅有关的工作平面图,以确定控制装置的安装位置。所需工具和材料(墙面安装)如下:
5.
A separate horizontal projection of louvers shades lower glazing.
单个的水平安装的百叶遮起了下面的玻璃。
6.
Consult the appropriate job plans to determine the controller mounting location.
请参阅有关的工作平面图,以确定控制装置的安装位置。
7.
The slave unit is located at the ground stations.
附属装置安装在地面台。
8.
Look éach other at development of surface mount technology and surface mount device in astonishment
表面安装技术与表面安装元件发展面面观
9.
The surface that the engine is mounted on must be on an even plane (i.e., a flat and level surface) so that there is no strain on the engine itself.
引擎安装必须是固定在一正平面背板上(即,平和平实表面)确定引擎外壳没有受到张力。
10.
The flame arrester can be installed horizontally or vertically.
本阻火器可水平安装，也可垂直安装。
11.
TQFP (Thin Plastic Quad Flat Pack
薄型方面平面封装)
12.
The installation of pig receiver& launcher is divided into above ground installation and underground installation.
收发球筒安装分地面安装及地下安装两种形式。
13.
Installation of steel structures and cladding. Fabricate and install docking, front wall steel structure. Precast concrete and stressing work.
安装钢结构及盖面板、平台和前墙结构建造安装，混凝土预制件及张拉工程。
14.
horizontal stabilizer trim control wheel
水平安定面配平手轮
15.
Pressure should be the formation of metal plates installed, straight, there should be no construction of the plate surface residue and dirt.
压型金属板安装应平整、直，板面不应有施工残留物和污物。
16.
Low the harnessed implement to a flat surface until the embedding legs touch it and the depth control wheels are in the air.
降低安装设备放置平面直到接触到掩埋臂，并且深度控制轮悬空。
17.
Study of Personalized Optimum Tilt Angle of Flat Solar Receivers
个性化的平面太阳能接收器件最优安装角度研究
18.
Optimization of the Tilt Angle of Solar Collectors Based on Forecast of Solar Irradiation
基于辐射预测的太阳能平面接收器安装角度优化