1.
Install adjuster nut and lock nut.
安装调节器螺母和防松螺母。
2.
To Readjust- Loosen lock nut on the adjusting screw.
重新调节：松开调节螺丝上的锁定螺母。
3.
roll nut adjusted quick grip pliers
螺母调节快速夹紧卡钳
4.
brake thrust screw
制动器止推调节螺钉
5.
feed regulator thumb screw
进料调节器指拧螺丝
6.
propeller governor drive
螺旋桨节距调节器传动装置
7.
To replace seat/ stem module shut off supply, loosen locknut and back off adjusting screw.
要更换阀座/杆模块，先关闭供应管道，松开锁紧螺母，退出调节螺丝。
8.
The research of nut adjustment on micro-car clutch fork
微型汽车离合器分离拨叉螺母调整的研究
9.
Attach the regulator. Fasten the regulator to the cylinder and tighten the inlet nut securely.
连接调整器。把调整器紧固在钢瓶上，安全地上紧入口螺母。
10.
All floor-mounted cabinets are supported on four leveling screws that are adjustable from access in toe base.
所有地面安装式柜体均由4个可调螺丝支撑，由踢脚板开口处调整螺母以调节台面水平。
11.
Never use pliers on a nut, while an adjustable spanner should only be used as last resort.
哪怕只有可调节的扳手才能奏效时，也一样不要用老虎钳来拧螺母。
12.
spring seat bearing adjusting nut
弹簧座轴承调整螺母
13.
wheel hub bearing adjusting nut
车轮毂轴承调整螺母
14.
steering gear adjusting nut lock
转向齿轮调整螺母保险
15.
hand-held electric nut setter
电动螺母安装器,手提式
16.
recirculating ball and nut steering gear
循环球和螺母式转向器
17.
Straight moving type relief valves, mainly valve disc, valve body,, spring-loaded, roof, regulation pole, conditioning nut, and other integral parts.
直动型溢流阀，主要有阀芯、阀体、弹簧、上盖、调节杆、调节螺母等零件组成。
18.
Using a screwdriver to adjust the thermostat pointer, set the thermostat( s) to the desired water temperature.
使用螺丝刀调节温控器上的指示器，设置所需要的水温。