1.
The gouge of the fault zone may extend to depths of some kilometers.
断层区的断层泥可能伸展到若干公里的深度。
2.
Research on Anti-breaking Structural Design of the Highway Tunnel across Active Fault Zones
活动断层区公路隧道抗错断结构设计的研究
3.
Alquist-Priolo earthquake fault zoning act: mitigating the hazard of surface faulting in California
阿尔奎斯特-普里奥罗地震断层区划 法案:减轻加州地表断层灾害
4.
APPLICATION OF HIGH-RESOLUTION SEQUENCE STRATIGRAPHY TO MIDDLE PART OF THE THIRD MEMBER OF SHAHEJIE FORMATION IN THE HE 125 FAULT AREA
高分辨率层序地层学的应用——以河125断层区沙三中亚段为例
5.
Requirements on the Design of Buried Pipelines in Active Fire Areas and the Preventive Measures Concerned
活动断层区埋地管道的设计要求及防范措施
6.
Sheet Sectional and Microsurgical Anatimic Studies of Orbital Apex Region;
眶尖区薄层断层解剖和显微外科解剖学研究
7.
Microsurgical and Sheet Sectional Anatomic Study of the Pterygopalatine Fossa Region;
翼腭窝区显微外科解剖与薄层断层解剖学研究
8.
The Causes and Countermeasures of "Faultage" of State Tax Personnel at Grassroots Level in Undeveloped Regions of China;
欠发达地区基层国税人员断层的成因与对策
9.
The thin transverse sectional anatomy of the pontocerebellar trigone region and its clinical significance
脑桥小脑角区的薄层横断层解剖及其临床意义
10.
Study on MRI and the Thin Anatomical Section Images in the Craniocervical Junction Region
颅颈结合区薄层断面影像解剖学研究
11.
Folding or faulting that affects a relatively large area.
褶皱或出现断层影响了相当大地区.
12.
Positron emission tomography of tinnitus-related brain areas
耳鸣相关脑区的正电子发射断层成像
13.
A still more difficult distinction is that between a sharp flexure and a fault.
区别尖锐的挠曲和断层更加困难。
14.
2) the effect of uniform slip of faults on the stress field;
2)断层均匀滑动对区域应力场的影响;
15.
Reservoir Flow Units of Intricate Fault Block in Shu 3 Area
曙三区复杂断块储集层流动单元研究
16.
Study on Mechanical Behavior of Tunnel Construction at Fault Zone with High Ground Stress
高地应力区断层带隧道施工力学研究
17.
If the strike of a fault is parallel to the general trend of regional structures, it is called longitudinal fault
如果断层走向与区域构造的总体走向相平行，就称之为纵向断层;
18.
If the strike of a fault is perpendicular or diagonal to the trend of regional structures, it is refer to transverse fault.
如果断层走向与区域构造线走向相垂直或斜交，则称之为横向断层。