1.
Detection and Characteristics of Heating Resistance of Cutting Zone in Electric Hot Machining
导电加热切削中切削区加热电阻的检测及特性
2.
Model of Heating Resistance of Shear Zone in Electric Hot Machining and Its Experiment Analysis
导电加热切削切削区加热电阻模型及试验分析
3.
Research of Electric Hot Machining to Improve Surface Quality;
利用导电加热切削改善已加工表面质量的研究(英文)
4.
Study of Characteristics of Tool Wear and Adaptability of Tool in Electric Hot Machining;
导电加热切削刀具磨损特性及刀具适应性的研究
5.
Heating a conductor rod increases its resistively .
将导体棒加热会增加其电阻率。
6.
heating of an insulator by a high-frequency electric field.
用快速变化的电磁场对非导电体加热。
7.
Research of High Frequency Induction Heating Power Supply for Preheats of the Cross-linked Polyethylene Copper Core Cable;
交联电缆铜导体预热感应加热电源的研究
8.
the heating of a conducting material caused by an electric current induced in it.
由导电物质内部电流的感应引起的加热作用。
9.
Effect of Ohmic Heating on Electrical Conductivity and Rheological Characterization of Pork;
通电加热对猪肉电导率和流变特性的影响
10.
Adopt heating technology of semiconductor,have good temperature evenness.
采用热惯性极小的半导体微电热加热技术，提高了温度均匀性。
11.
Increasing the wattage and/or voltage from factory original equipment can require changes to the water heater and/or the electric service.
对工厂原装的热水器增加电源功率和／或增加电源电压可能导致热水器和／或电路系统产生变化。
12.
Complete failure of the heating elements will result if they are not totally immersed in water at all times.
如果在通电的过程中,电加热棒没有浸泡在水中,可能会导致电加热棒烧坏。
13.
electric brazing
电加热钎焊;电热钎焊;电热铜焊;电热硬钎焊
14.
heater flue couple
加热炉废气的热电偶
15.
indirectly heated thermistor
间接加热式热敏电阻器
16.
heater bridge wall couple
加热炉隔墙测温热电偶
17.
Conducting ring, pipe heater, bearing, synchronous belt, conveyance belt and so on are of import brands.
导电环、加热管、轴承、同步带、输送带等采用进口产品。
18.
(of a substance)allow(heat,electric current,etc)to pass along or through it
（指物质）传导（热、电流等）