1.
calibration equipment of reversing thermometer
颠倒温度表检定设备
2.
Systematic Comparison between CTD and Reversing Thermometer and Salinity Monitor
CTD与颠倒温度表、盐度计方法的系统比较
3.
Water quality-Determination of water temperature-Thermometer or reversing thermometer method
GB/T13195-1991水质水温的测定温度计或颠倒温度计测定法
4.
Inspection methods for basic parameters of environmental testing equipments for electric and electronic products--Temperature testing equipments
GB/T5170.2-1996电工电子产品环境试验设备基本参数检定方法温度试验设备
5.
Establish proper injector and detector temprature.
给进样口和检测器设定恰当的温度。
6.
The Study of Temperature Monitoring System of Electric Device Based on Optical-fiber Fluorescence;
基于光纤荧光的电力设备温度检测系统的研究
7.
Infrared Imaging Method in Electric Equipment Gas Temperature Ascending Insp ection
红外成像法检测电气设备本体的温度升高
8.
The Verification Methods and Troubleshooting of Digiatl Temperature Integrator
数字温度二次仪表的检定方法和故障排除
9.
Furnace and Thermal Processes- Equipment with a temperature gauge used for processing wafers. A constant temperature is required for the process.
炉管和热处理-温度测量的工艺设备，具有恒定的处理温度。
10.
The Design of Temperature and Positioning Control System for Perforator Target Device
射孔器打靶检测装置温度及定位控制系统设计
11.
The Uncertainty Analysis of Digital Theraml Couple Temperature Instrument Calibrator
校验仪检定配热电偶数字温度二次仪表不确定度分析
12.
Set the number of degrees that any heated component can exceed its assigned set-point temperature before an over temperature fault occurs.
严格限定所有受热零部件温度高于所设定最高运行温度的度数，以防设备过热而出现故障。
13.
Constitute the circuit checking regulation and spot-check it.
制定设备的巡回检查制度，并抽查落实情况。
14.
Setting of Object Surface Temperature of Casting Slab Based on Support Vector Regression
基于支持向量机回归的铸坯表面目标温度设定
15.
reverse procedure
颠倒程序，颠倒步骤
16.
Motor vehicle safety testing equipment-Technical requirements of verification for speedometer tester of roller type
GB/T11798.4-1989汽车安全检测设备滚筒式车速表试验台检定技术条件
17.
Sets the number of degrees that any heated component can drop below iits assigned set-point temperature before an under temperature fault occurs.
严格限定受热零部件温度的降低幅度，以防设备因过冷而出现故障。
18.
Motor vehicle safety testing equipment-Technical requirements of verification for filter type smokemeter
GB/T11798.5-1989汽车安全检测设备滤纸式烟度计检定技术条件