1.
The Equivalent Resistance of a Two-Dimensional Non-symmetric Random Two-Terminal Resistor Network;
二维非对称无规二端电阻网络的等效电阻
2.
The value of the bias resistors is dependent on termination and number of nodes in the system.
偏置电阻的值取决于终端电阻的大小及系统的节点数。
3.
a 3-terminal resistor with an adjustable center terminal; used to adjust voltages in radios and TV sets.
带有一个可调节的中心接线端的三终端电阻；用来调节收音机或电视机中的电压。
4.
The dominant module uses a different resistor and capacitor than a standard module.
主要模块采用的终端电阻和电容与标准模块不同。
5.
Termination resistors should be placed only at the extreme ends of the data line, and no more than two terminations should be placed in any system that does not use repeaters.
终端电阻只能安装在数据线的最末端，在没有使用中继器的系统中，不得使用两个以上的终端电阻。
6.
resistance box with terminals
端接[钮] 式电阻箱
7.
three-terminal standard resistor
三端（钮）标准电阻器
8.
four-terminal standard resistor
四端（钮）标准电阻器
9.
USING THE EQUIVALENT TRANSFORMATION FROM A FOUR-TERMINAL STAR RESISTANCE NETWORK TO THE FOUR-TERMINAL MESH RESISTANCE NETWORK TO GET THE EQUIVALENT RESISTANCE OF ASYMMETRIC TIAN RESISTANCE NETWORK
用四端星形电阻网络到四端网状电阻网络的等效变换求田字形不对称电阻网络的等效电阻
10.
A voltage results across the resistor.
这时在电阻器两端产生了一个电压。
11.
Study on the Numerical Simulation for Resistance Spot Welding with Rectangular Tip Electrode;
矩形端面电极电阻点焊数值模拟研究
12.
Discussion on Grounded Resistance of Client End in 20 kV Substation
客户端20kV变电所接地电阻值的探讨
13.
Technology for End-coating Chip Resistors and the Structure and Principle of the End-coating Machine
片式电阻器封端工艺及封端机的结构原理
14.
Numerical simulation of the temperature field during resistance spot welding with rectangular electrode
矩形端面电极电阻点焊温度场数值模拟
15.
Method for Computing the Value of the Resistor Connected in Series between the Output and Input of Gate Circuits;
串联在门电路输出端与输入端之间电阻的计算技巧
16.
A resistor-condenser circuit at the input to the vertical oscillator.
位于垂直振荡器输入端的一种阻容电路。
17.
Using an Ohmmeter, connect a lead across the two terminals.
用一个电阻计，将一段导线跨接两个端子。
18.
Design of a terminal sliding mode speed controller for switched reluctance motor
一类开关磁阻电机的终端滑模控制器设计