1.
Install the new upper rear bearing oil seal with the white paint facing towards the rear of the engine.
安装新的上后轴承油封，使白漆面向引擎后部。
2.
Remove thrust bearings from rear main bearing carrier.
从后主轴承托架上拆下止推轴承。
3.
Shaft Assembly (Male, female, washer, grease….
轴组件（轴，轴套，轴承，油脂。。。）
4.
production line of ball bearing after assembly
球轴承装配后工序生产线
5.
Bearing Clearance (#1 Journal)
轴承间隙（#1轴颈）
6.
plain bearing housing with bearings
装有轴承的普通轴承座
7.
housing bearing plain without bearings
未装轴承的普通轴承座
8.
radial Bearing and thrust Bearing
横力轴承与推力轴承
9.
cageless bearing
无保持架轴承,开口轴承
10.
upper center crankshaft bearing
曲轴主轴承上中轴瓦
11.
First you need the boring for the shaft, then install the stern tube into the stern frame, next fit the gun-metal or white-metal bush.
首先要镗孔，然后安装尾轴管，接下来装炮铜或白合金制的轴承套，也叫轴承。
12.
"Semifinished main bearings require finishing and fitting after installation, so that the crankshaft must be taken out."
半精加工的主轴承安装后需要修整和调配,这样曲轴就必须拆下。
13.
Remove the depth shims from rear pinion bearing cup bore in axle housinRecord the thickness of the depth shims.
从轴管里的后小齿轮轴承盖孔拆卸限深垫片。记录限深垫片厚度。
14.
Heavy-duty thrust bearing; locked to prevent axial movement.
坚固耐用的止推轴承；锁定后有利于阻止轴向运动。
15.
Oil may be forced out through the timing cover and rear-main bearing oil seals.
机油会从正时齿轮盖和后主轴承油封处压出。
16.
Permanently sealed and lubricated ball bearings front and rear.
前后端盖装有永久密封和自润滑的滚珠轴承。
17.
The application of post-processed Galerkin method in rotor-bearing systems
后处理Galerkin方法在转子-轴承系统降维中的应用
18.
Experimental Investigation into the Transient Response of a Flexible Rotor Dropping on a Back-up Bearing After Active Magnetic Bearing Failure
主动电磁轴承失效后柔性转子坠落在备用轴承上的瞬态响应实验研究