1.
Influence of Bolt Pretightening Force to GIS Shell Flange Intensity
螺栓预紧力对GIS壳体法兰强度的影响
2.
Analyze on bolt pre-tightening force control methods of Ba-Tong damper
八通缓冲器联接螺栓预紧力控制方法分析
3.
High-strength bolts were inserted into the holes and tightened to a high preload level.
把高强度螺栓插入孔洞，同时拧紧螺栓达到高的预加载水平。
4.
Stress Analysis of Composite Laminate Connected by Preloaded Bolt
复合材料层合板预紧螺栓连接应力分析
5.
Two Ways of Calculating General Pulling Force of Tight Screw Bolt Linking with Beforehand Light Strength and Work Pulling Force;
受预紧力和工作拉力的紧螺栓联接的总拉力的两种计算方法
6.
Studies on the Ways of Calculating General Pulling Force of Tight Screw Bolt Lin king with Beforehand Light Strength and Work Pulling Force;
受预紧力和工作拉力的紧螺栓联接的总拉力计算方法研究
7.
tightening bolt
拉紧螺栓，(铁)风口拉杆
8.
Improper bolt tightening procedure.
螺栓拧紧程序错误。
9.
maneton clamp bolt
可拆卸曲柄颊夹紧螺栓
10.
square collar-head set-bolt
方头凸缘端紧定螺栓
11.
" Tolerances for fasteners--Bolts, screws and nuts"
GB/T3103.1-1982紧固件公差螺栓、螺钉和螺母
12.
Design Methods for Pre-tightening Forces and Permitted External Forces Acted on a Bolted Joint Based on 3D FEM Computation;
基于有限元计算的螺栓接头预紧力和允许外力设计方法
13.
a hand tool that is used to hold or twist a nut or bolt.
用来上紧或扭螺母或螺栓的手工具。
14.
Fasteners--Clearance holes for bolts and screws
GB/T5277-1985紧固件螺栓和螺钉通孔
15.
Hold puller screw and tighten puller nut until bushing is remove
握紧拉拔器螺栓，拧紧拉拔器螺母，直至拆下衬套。
16.
" Mechanical properties of fasteners--Bolts, screws and studs"
GB/T3098.1-1982紧固件机械性能螺栓、螺钉和螺柱
17.
hydraulicdevice for tightening tie-bolt
贯穿螺栓上紧用液压装置
18.
Lock rings at the end of shaft with bolt
GB/T892-1986螺栓紧固轴端挡圈