说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 高压冷却剂注入系统
1.
high pressure coolant injection system
高压冷却剂注入系统
2.
low pressure coolant recirculation system
低压冷却剂再循环系统
3.
No refrigerant in the refrigerant system.
冷却系统中没有冷却剂。
4.
Continue to fill the system until the coolant tank is full.
持续填注冷却系统,直到冷却剂贮藏箱填满。
5.
Fill cooling system (refer to Group 7, Cooling System for the proper procedure).
注入冷却系统(有关正确程序请参阅单元7,冷却系统)。
6.
Research on the Technique of Distributed Control System for Pressurized Water Reactor Coolant System;
压水堆核电厂主冷却剂集散控制系统技术研究
7.
DO NOT LOOSEN RADIATOR DRAINCOCK WITH SYSTEM HOT AND PRESSURIZESERIOUS BURNS FROM COOLANT CAN OCCUR.
当系统灼热和处于高压状态时,不要松开散热器排放栓●则会被冷却剂严重烧伤。
8.
the cooling was overhead fans.
冷却系统是高架风扇。
9.
reactor coolant system dose equivalent
反应堆冷却剂系统剂量当量
10.
Upgrading the Cooling System of Ultra-high Voltage Transfers (500 kV) of Datang Yantan Hydropower Co.,Ltd.
大唐岩滩水力发电有限责任公司500kV超高压变压器冷却系统改造
11.
TEMPERATURE GAUGE READS HIGCOOLANT MAY OR MAY NOT BE LOST OR LEAKING FROM COOLING SYSTEM
温度计读数偏高。冷却剂可能从冷却系统中流失或泄漏,也可能不这样。
12.
charging/make-up flow [reactor coolant system]
上充/补给水流量〔反应堆冷却剂系统〕
13.
Current situation and development of biocide to cycle-cooling water system;
循环冷却水系统杀生剂的现状与发展
14.
Research and Development on Cooling System of Injection Mold CAD
注塑模具CAD冷却系统的研究与开发
15.
Analysis on the Cooling System for Injection Mold of Bottom Cover based on Moldflow
基于Moldflow的底座注塑模冷却系统分析
16.
Research on CAD/CAE Technology for Cooling System Unit of Plastic Injection Molds
注塑模具冷却系统库的CAD/CAE技术研究
17.
Cooling System Pressure Tester—7700–A
冷却系统压力测试器—7700–A
18.
Frequency Transformation of Water Cooling System in Wind Pressure Room in Nanshan Coal Mine
南山矿压风机房水冷却系统变频改造