1.
Remove the headlamp switch knob and shaft from the headlamp switcSee Headlamp Switch in this group for the procedures.
请将头灯开关按钮和轴从头灯开关中拆下。请参考本单元的头灯开关的程序。
2.
Remove the headlamp switch from the instrument panel.
请从仪表板上拆下头灯开关。
3.
WHILE READING THE LOW BEAM SENSE STATUS, TURN THE HEADLAMP SWITCH OFF THEN BACK ON.
当读近光感知状态时，将头灯开关转为关，然后恢复为开。
4.
Position switch into license plate lamp housing and connect switch harness connector.
定位开关到牌照灯壳，连接开关线束接头。
5.
If equipped with a motorized headlamp leveling system, ensure the headlamp leveling switch is in the 0 position.
若配有一个机动的头灯调平系统，确保头灯调平开关在0位置。
6.
turn off the light, oven, tap
关上灯、 烤箱、 龙头
7.
Brake Lamp Switch Output (to Lamps)
刹车灯开关输出（对灯）
8.
Start-up: After the lamp holder is connected with the power system, turn the main switch to ON and the flash indicator lamp○6 will turn red.
开机：灯头与电源机身连接好后，总开关向ON拨动，随后闪光灯机身指示灯⑥（红色）闪动。
9.
Automatic Switch of Energy-saving Lights Based on Pyroelectric Infrared LN074B Probe
基于热释红外探头的电灯节能自动开关
10.
ARE THE HIGH BEAM HEADLAMPS ON?
远光头灯打开了吗？
11.
The lamp holder plug insertion double headed attachment point, the lamp brightly starts to work.
灯头插头插入双头连接处，灯亮开始工作。
12.
Press the power switch at the top of the flashlight to light on the LED indicator. Press again to switch off .
按下电筒头部电源开关,LED灯源点亮,再按一下即可关闭.
13.
Test the lamp by depressing the lens to check for proper lamp switching and lighting.
测试灯光：按压灯罩检查适当的灯开关和灯光。
14.
There is a switch on the wall for turning on the lights.
墙上有一开电灯的开关。
15.
We touch a switch to flood a room with light.
我们打开电灯开关使室内灯光明亮。
16.
The light switch is on your right.
电灯的开关在你的右侧
17.
He says I never turn them out when I leave.
他说我离开时从不关灯。
18.
Be sure to turn off the lights when you leave the room.
离开房间时，一定要关灯。