1.
Starting 180 degrees from last pilot bolt, tighten 3 large bolts all the way (any sequence).
从最后一个导向螺栓开始每隔180度，将3个大螺栓分别拧紧全部行程（按任何顺序）。
2.
Starting 180 degrees from the last pilot bolt, tighten 3 large hole bolts 3/4s of the way (any sequence).
从最后的导向螺栓开始每隔180度将3个大孔螺栓分别拧紧全部行程的3/4（按任何顺序）。
3.
hinge (guide) bracket bolt
绞链(导向)托架螺栓
4.
" Bolts, small hexagon head with fit neck and hole through the shank"
GB/T24-1976小六角头螺杆带孔导颈螺栓
5.
"Bolts,screws & nuts"
"螺栓,螺丝及螺帽"
6.
Tie Rod End To Steering Knuckle Nut
转向拉杆端与转向关节螺栓
7.
" Bolts, small hexagon head with fit neck and holes through the head"
GB/T26-1976小六角头头部带孔导颈螺栓
8.
" Bolts, small hexagon head with fit neck"
GB/T22-1976小六角头导颈螺栓
9.
Tie Rod End Adjusting Sleeve Nut
转向拉杆端调整轴筒螺栓
10.
double-screw bolt
螺柱，双头螺纹螺栓
11.
threaded bottom guide
有螺纹的底部导向鞋
12.
Remove the universal joint strap bolts at the pinion shaft yoke.
在小齿轮轴轴轭处拆卸万向节扣夹螺栓。
13.
Using a wrench, loosen the diaphragm assembly by turning the hex bolt counterclockwise.
用扳手反时针方向旋转六角螺栓，松开隔膜总成。
14.
Illustration of the Difficult Problem of Tight Bolt Fastening Against the Horizontal Working Loads In Mechanical Design Theory;
“承受横向工作载荷的螺栓联接”的解疑尝试
15.
Studies on two-way T-shaped bolt in rubber dam sticking craft;
双向“T”型螺栓在橡胶坝袋粘补工艺中的应用
16.
Research of Recognition Algorithm for Plate Bolt of Train Wagon Bogie
货车转向架心盘螺栓丢失识别算法研究
17.
Research and Prospect on the Technique for Bolt Axial Stress Measurement
螺栓轴向应力测量技术的研究概况及展望
18.
draw-bar carrier bolt
牵引杆托(板)螺栓