1.
Investigation of Compressor Stability with Distortion by Inlet Insert-board;
压气机进口插板总压畸变稳定性研究
2.
The Calculation of Inlet Guide Vane Deviation Angle for an Axial Compressor
轴流式压气机进口导叶滞后角的计算
3.
exhaust gas intake port
（气波增压器）排气进口
4.
Numerical Simulation of Effect of Inlet Total-Pressure Distortion on Subsonic Axial-Flow Compressor
进口总压畸变对亚声速轴流压气机流场影响数值研究
5.
air compressor suction strainer
空气压缩机进风滤尘器
6.
Based on the experiment of a low-pressrue vortex blower, the influence of the di fferent blower inlet area on its performance has been investigated.
通过实验，分析了不同进气口面积对低压旋涡风机性能的影响。
7.
The two types of engine valves are intake and exhaust.
发动机气门的二种型式是：进气口和排气口。
8.
Connect the suction/discharge hose to the compressor.
连接进气/排气软管至压缩机。
9.
Numerical simulation of the inlet total temperature distortion in the compressor
进气总温畸变在压气机中的数值模拟
10.
booster compressor
升压压缩机,增压压气机
11.
Air Compressor Intakes or Inlets to Ventilating or Air Conditioning Equipment
气体压缩机的通风的入口或空调设备
12.
DISCUSSION ON PIPING CORROSION AT QUENCH-AIR COMPRESSOR SUCTION
激冷气压缩机入口管道腐蚀问题探讨
13.
Experimental study of inlet total-pressure distortion on four kinds of flat baffles
多种形式插板的压气机进气总压畸变实验
14.
"At the same time, the intake port, now cleared by the piston, begins to deliver air-fuel mixture, under pressure, to the cylinder."
同时,活塞使进气口露出,受压缩的可燃混合气开始进入气缸。
15.
The compressor-outlet pressure is nearly constant around the circumference.
压气机出口压力沿圆周方向接近于常数。
16.
This pressure closes the reed valve so that further downward movement of the piston compresses the trapped air-fuel mixture in the crankcase.
当活塞向下运动直到露出进气口,可燃混合气所具有的压力使其上升,通过进气口进入气缸。
17.
In an air jet loom, high pressure air carries the filling yarn through the shed.
在喷气织机上,高压气流携带纬纱穿过梭口。
18.
Study on Intake Performance of SI Engine with Fully Variable Valve Hydraulic Actuation System
发动机全可变液压气门机构进气性能的研究